Connecting Video
With the power to your computer and the monitor off, connect the supplied video
cable from the monitor to the computer's VGA port (Figure 6).
Make sure the VGA cable connector is securely connected to the VGA port on
your computer. Tighten the connecting screws to ensure a secure connection.
Turn the monitor on first, then turn on the computer. The LED on the monitor
will flash until it receives a video signal from the system.
Connecting Optional Stereo Speakers
Connect the supplied audio cable to the line-out port of your computer's audio
card. Next connect the other end of the audio cable to the monitor's line-in port
(Figure 7, shown with video cable also attached).
Adjust the sound volume of the stereo speakers by using either the speaker
volume control function on the On-Screen Display (OSD) or the Adjustment
increase and decrease buttons (see Figure 8) on the front of the monitor.
Note: Planar does not recommend using the audio from the monitor as
your exclusive audio source in medical applications.
Operations Manual (OM700-02)
Figure 6: Connecting the Monitor to Your System
Figure 7: Connecting the Stereo Speakers
11