Power Source; Auto Clock Setting; Remote Control; Setting The Video Channel - Toshiba D-VR4SU Owner's Manual

÷
clock setting /
NOTES:
, When shipped from factory, the
video channeB is set to CN 3.
, tf the unit does not operate prop-
erly, or there is no key operation
from the unit and/or the remote
control: Static electricity, etc. may
affect the operation= Disconnect
the AC power cord once, then con-
nect it again=
Setting the video channeH
Auto c_ock setting
Preparation:
You must connect the antenna or cable before connecting the AC cord
to the power source.
Wait at least 3 minutes with the power turned off, after the antenna or
cable is connected, for the auto clock feature to activate.
After the clock is set automatically, you may have to set the time zone
and daylight saving time. (See page 26.)
Press ON/STANDBY to turn on the DVD/VCR after the auto clock op-
eration completed.
• When shipped from factory, the "AUTO CLOCK" option is set to "ON"
position.
• if you turn the DVD/VCR on during auto clock setting, the clock is not
set.
• Dependimg on the reception condition, auto clock setting may take
approx. 30 minutes.
• After a power failure or disconnection of the power plug, the clock will
be lost. in this case, wait 3 minutes before turning the DVD/VCR on.
• With cable box connection, if the auto clock setting is unsuccessful,
select the PBS channel carrying the XDS information, then turn the
DVD/VCR off. After 3 minutes, turn the DVD/VCR on.
• if the clock is not set automatically, set the clock manually. (See page
26.)
Setting the video channel
To view pmayback of a recorded tape or DVD disc, or to watch a
program semected by the VCR's channel selector, the TV must be
set to channel 3 or 4 (video channel),
When a TV is connected with the 75 ohm coaxial cable only:
Press and hold 3 4 the remote controI for 3 seconds in the
or on
standby mode to select CH 3 or 4. The selected channel number
will flash on the dispIay for about 4 seconds=
Turn ON the TV and set to CH 3 4 to with the chan-
or correspond
nel selected in step 1=
Press ON/STANDBY to turn on the DVD/VCR.
4
5
Press TV/VtDEO to seIect the VIDEO position=
The TV indicator will disappear in the display=
Select any channel to receive a TV station in your area.
The channel number will appear on the screen for about 4 sec-
onds.
For a push-button TV tuner
If CH 3 or 4 corresponding to the video channel cannot be tuned on
your TV, proceed as fol!ows: set the VCR 3/4 channel selector and the
TV to CH 3 or 4, playback a prerecorded tape and tune the TV to re-
ceive a sharp color picture from the video cassette recorder. Refer to
your TV owner's manual for details=
÷
2G10101A P22-P32 22 _ 2/25/05, 1:30 AM