Sony Handycam DCR-PC109 Operation Manual page 17

Handycam Station.
After charging the battery
The CHARGE lamp turns oft" when the battery
is fully charged. Disconnect the AC Adaptor
from the DC IN jack.
To remove the battery pack
Battery pack
'7 Slide the POWER switch up to OFF
(('HG).
The CHARGE lamp lights np and charging
starts.
POWER
CHARGE ' MODE
;J
To charge the battery pack using only
the AC Adaptor
POWER
switch
BATT =j (battery release) lever
1
2
Set the POWER switch to OFF (CHG).
Slide the BATT _j (battery release)
lever in the direction of the arrow as
shown in the illustration and remove the
battery pack.
fO Note
• Ahvays attach the tezminal covel to protect the
battel 7 telminal If you do not use the battel 3, pack
tbr a long time, use up the battel 3, pack cmupletely
before storing it See page 131 about storage of the
battel_" pack.
To checktheremaining battery- Battery
Info
m
¢D
_D
AC Adaptor
To the wall outlet
You can charge the battery pack on a trip, even
if you have not brought the Handycam Station
along. With the • mark on the D( plug facing
up, connect the AC Adaptor to the DC IN jack
on your camcorder as shown in the illustration.
DISPLAY/BATT INFO POWER switch
You can check the battery's cnrrent charge level
and its current remaining recording time both
during charging or when the power is turned off.
,_continued
Getting started 17