Messages - Sony MZ-S1 Operating Instructions Manual

Messages
If the lbllowing messages flash in the display window, check the messages below.
Error message Meaning/Remedy
BLANK • An MD with no recording on it is inserted.
BUSY • You tried to operate the recorder while it was accessing the recorded
data.
Wait until the message goes out (in rare cases, it may take a few
minutes).
Saving • The MD player is recording inlbrmalion (sounds) from the memory
to the disc.
Wait until this process is completed. Do not expose the player to
any physical shock, nor disrupt power supply.
ERROR
• Recording was not correctly done.
Place the recorder at a place with no vibrations and record again.
• The disc is soiled with an oil film or finger prints, is scratched, or is
not a standard disc.
•"_ Try recording again with another disc.
• The recorder cannot read the disc intbrmation correctly.
•"_ Reinsert the disc.
• The recorder cannot read the disc intbrmation correctly.
Insert another disc.
If it is no problem to erase the entire disc, do so (page 44).
FULL • The remaining recording time on the disc is 12 seconds (stereo), 24
seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or less.
Replace the disc.
lliDCin • Voltage of the power supply is too high (The supplied AC power
adaptor or the recommended car battery cord is not used).
Use the supplied AC power adaptor or the recommended ear
battery cord.
ItOLD • The recorder is locked.
Slide HOLD against the arrow to unlock the recorder (page 16,
47).
LoBATT • Battery is weak.
Replace the dry battery (page 15).
MEMORY • You tried to record with the recorder placed where it receives
continuous vibration.
Put the recorder on a stable place, and starl recording again.
62