Direct Button Operation - Sharp LC-19LS410UT Operation Manual

Direct Button Operation
®®®
®®®
®®®
®®@
FREEZE SURROUND FLASHBACK
SLEEP MENU
6v'NN
• Each time INPUT is pressed, the
input source toggles.
° If you press A/T to select the
input source, press ENTER to
confirm your selection.
See page 17-18 for external equipment
connection.
You can change channels by pressing
CH A/V or 0-9, or ° (DOT}.
Examples:
To select a I or 2-digit channel number (e.
g., Channel 5):
Press 5
--->
ENT.
To select
a 3-digit
channel number
(e.
g.,
Channel 115}:
Press 1 _ 1 _ 5_ ENT.
To select
a 4-digit
channel number
(e.
g.,
Channel
22.1}:
Press 2 _ 2 _
• (DOT)
_ 1
ENT.
• When selecting a 1-digit channel
number, it is not necessary to press 0
before the number.
You can change the volume by pressing
VOL +/- on the TV or on the remote
control unit.
° To increase the volume, press
VOL+.
° To decrease the volume, press
VOL-.
To view external source images, select the
input source using INPUT on the remote
control unit or INPUT on the TV.
1. Press INPUT.
° A list of selectable sources
appears.
2. Press INPUT again to select the input
source.
° An image from the selected source
automatically displays.
Mutes the current sound output.
Press MUTE.
Mute can be canceled by using the
method below.
- Mute will be canceled if you press
VOL+/- or MUTE.
Allows you to set a time when the TV
automatically switches to standby.
Press SLEEP.
• The remaining time displays when
the sleep timer has been set.
• Each time you press SLEEP, the
remaining time switches as shown
below.
Off, 10, 20, 30, 40, 50, 60, 90, 120
• When set, the time automatically
starts counting down.
• If you want to adjust the sleep
timer, you can press SLEEP twice
then change the time setting.
• One minute before the time
expires, the remaining time
displays every second.
• Select "Off" by pressing SLEEP to
cancel the sleep timer.
° The TV will enter standby mode (power
indicator lights red) when the remaining
time reaches zero.
(D- 21