Stopping; Slopes; Height Of Cut; Before Mowing - Hayter Harrier 56 560G Owner's Handbook Manual

OPERATING THE MOWER

Stopping

Release the ground drive clutch lever and release the
engine stop lever.
Emergency stop: As above. If the engine fails to stop
disconnect the spark plug lead. (Refer fig.11)

Slopes

To prevent engine damage do not use the mower on
slopes greater than 20 degrees. (Refer fig.12)

Height Of Cut

To adjust the height of cut: Grip the lever and pull side-
ways to disengage it from the locking notch, then push
forwards to lower or pull backwards to raise the height
of cut. Finally release the lever at the required position
and ensure it locks firmly into one of the eight setting
notches.
Always select a height of cut to suit operating conditions.
Aim to prevent engine overloading and blockages by
avoiding low cuts in long grass conditions. Be prepared
to make two cuts when the grass is long. (Refer fig.13)

Before Mowing

To prevent accidents, thoroughly inspect the area
and remove all objects which when contacted by the
mower cutterblade could become dangerous projec-
Fig. 11 Fig. 12
tiles. Inspect the area for hidden obstructions which
when contacted by the cutterblade could risk health
and safety or result in damage to the mower. Remem-
ber the location of these obstructions and ensure that
you mow around them. (Refer fig.14)

Grassbag

Raise the rear deflector and lift the grassbag and lower
the rear deflector to rest against the rear of the mower.
To empty the grassbag, pour out the grass clippings and
shake the grassbag vigorously to clean the airways. Good
grass collection depends on good air flow through the
grassbag. When collecting grass clippings it is important
that the grassbag is emptied regularly to prevent block-
ages and engine overloading. (Refer fig.15)

Without Grass Collection

Remove the grassbag and operate the mower with the
rear deflector in the closed position. (Refer fig.16)

Heavy Growth

Areas of heavy growth should be mown without
collecting the clippings. If collection is required, first
mow the area without the grassbag at the maximum
height of cut setting. Allow the grass clippings to dry
out and then mow the area at the maximum height of cut
setting with the grassbag fitted. Reduce the height of cut
Fig. 14
Fig. 13
+
-
20
and mow the area again as necessary until the required
finish is obtained.
To prevent damage to your lawn do not remove more
than one third of grass height in one cut. (Refer fig.17)
Fig. 15
9
Fig. 16
Fig. 17