Table of Contents
Advertisement
ASSEMBLY
Read these instructions and this manual in its entirety before
you attempt to assemble or operate your new lawn mower.
IMPORTANT: THIS LAWN MOWER IS SHIPPED WITH-
OUT OIL OR GASOLINE IN THE ENGINE.
Your new lawn mower has been assembled at the factory
with the exception of those parts left unassembled for ship-
ping purposes. All parts such as nuts, washers, bolts, etc.,
necessary to complete the assembly have been placed in
the parts bag. To ensure safe and proper operation of your
lawn mower, all parts and hardware you assemble must
be tightened securely. Use the correct tools as necessary
to ensure proper tightness.
TO REMOVE
LAWN MOWER
FROM CARTON
1.
Remove loose parts included with mower.
2.
Cut down two end corners of carton and lay end panel
down flat.
3.
Remove all packing materials except padding between
upper and lower handle and padding holding operator
presence control bar to upper handle.
4.
Roll lawn mower out of carton and check carton thor-
ougly for additional loose parts.
HOWTO SET UPYOUR
LAWN MOWER
TO UNFOLD
HANDLE
(See Figs. 1 and 2)
IMPORTANT:
UNFOLD HANDLE CAREFULLY SO AS
NOT TO PINCH OR DAMAGE CONTROL CABLES.
1.
Raise lower handle to operating position and align hole
in handle with one of the height positioning holes in
the handle bracket.
2.
Insert handle bolt through handle and bracket and
secure with knob.
3.
Repeat for opposite side of handle.
4.
Remove protective padding, raise upper handle sec-
tion into place on lower handle and tighten both handle
knobs.
5.
Remove packing material from around control bar.
Your handles may be adjusted for your mowing comfort.
Refer to "ADJUST HANDLE" in the Service and Adjustments
section of this manual.
OPERATOR
PRESENCE
CONTROL
BAR
MOWING
POSITION
L_/
/
uP
\
Y
UPPER
HANDLE
HANDLE
KNOB
LOWER
HANDLE
FIG. 1
KNOB
\
"
_
BOLT
HANDLE
BRACKE1
FIG. 2
4
Advertisement
Table of Contents
