Table of Contents
Advertisement
OPERATION
TO EMPTY GRASS CATCHER (See Figs. 10-11)
1.
Open round door of discharge chute to move starter
rope out and away from grass catcher.
/
FRONT
OPEN
HANDLE
ROUND
STARTER
FIG. 10
2.
Remove grass catcher with clippings from lawn mower
using both front and rear handles.
3.
Empty clippings from bag using rear handle and strap.
The weight of the grass will open the door.
4.
Snap door shut over frame before installing grass
catcher on mower.
NOTE: Do not drag the bag when emptying; it will cause
unnecessary wear.
\
STRAP
\
\
\\
\
\\
'\,
\
\
\\\
REAR
HANDLE
FRONT
BEFORE STARTING
ENGINE
ADD OIL (See Fig. 12)
Your lawn mower is shipped without oil in the engine. For type
and grade of oil to use, see "ENGINE" in the Maintenance
section of this manual.
I
_
CAUTION: DO NOT overfill engine with
ABk
oil, or it will smoke heavily from the mu-
tier on startup,
1.
Be sure lawnmower is level.
2.
Remove oil dipstick from oil fill spout.
3.
You receive a container of oil with the unit. Slowly
pour the entire container down the oil fill spout into the
engine.
4.
Insert and tighten dipstick.
IMPORTANT:
•
Check oil level before each use. Add oil if needed. Fill
to full line on dipstick.
•
Changethe oil after every25 hours of operation or each
season. You may need to change the oil more often
under dusty, dirty conditions.
See "TO CHANGE EN-
GINE OIL:' in the Maintenance section of this manual.
OIL FILL CAP/
DIPSTICK
GASOLINE
CAP
UPPER
LOWER
MARK
MARK
FIG. 12
FIG. 11
9
Advertisement
Table of Contents
