Table of Contents
Advertisement
Switching ANALOG/DIGITAL
Signal Input
The input of the component
set in the digital input setting (Refer to page 20, 21) can be switched to an analog or digital
input signal by pressing the SIGNAL SELECT button.
1
Press SIG. SELECT on the remote
control or SIGNAL
SELECT on the front panel to select the input signal
corresponding
to the source component,
- SIG.SELECT
Each press switches between ANALOG and DIGITAL signal selection.
SIGNAL SELECT
While SIGNAL SELECT is set to DIGITAL, AC-3 lights when a Dolby
Digital signal is input, and DTS lights when a DTS signal is input
"" When a Dolby Digital signal is input.
-" I When a DTS signal is input.
• SIGNAL SELECT is fixed in the "ANALOG"
position for components
not
assigned to one of the four (three on VSX-D5O8) digital input jacks.
• Because the audio from a karaoke microphone
and LD recorded with
analog audio only is not output from the digital output, set SIGNAL
SELECT to "ANALOG".
• This receiver can only play back Dolby Digital, PCM (32kHz, 44kHz, and
48kHz), DTS (VSX-D608 only) digital signat formats. With digita_ signal
formats other than these, set SIGNAL SELECT to "ANALOG".
• When an LD or CD player compatible
with DTS is played back with
SIGNAL SELECT set in "ANALOG",
digital noise is output caused by
playing back the DTB directly/no
decodingl.
To prevent noise, you need to
make digital connections
(Refer to pages 20, 21) and set SIGNAL SELECT
to "DIGITAL".
• Some DVD players don't output DTS signals. For more details, refer to the
instruct{on
manual supplied with your DVD player.
29
<ARB7157>
Hide quick links:
Advertisement
Table of Contents
