Playing Sources With Dolby Digital Or Dts Sound - Pioneer VSX-D508-G Operating Instructions Manual

Playing Sources with Dolby Digital or DTS Sound
5
3
2
1
Follow steps 1 to 3 of the playback procedure, (Refer to
"Playback" on page 40.)
_i' Turn on the power of the playback component•
21 Press RECEIVER to turn on the receiver.
r3" Press FUNCTION to select the source component you want to play.
2
Press SIG.SELECT on the remote control or SIGNAL
SELECT on the front panel to select DIGITAL.
(Refer to "Switching ANALOG/DIGITAL signal input" on the previous
page.)
3
Press DO to switch the i3D/DTS (VSX-D608) or 011 (VSX-
D508) mode on.
Each press changes the D_]DTS mode. (VSX-D608)
(Refer to "Switching the []/DTS mode" on page 32,)
4
Start playback of the component you selected in step 1.
1
3
i
2 5
5 Press VOL {+/-) to adjust the volume level.
• When an LD or CD player compatible with DTS is played back with
SIGNAL SELECT set in "ANALOG", digital noise is output caused by
playing back the DTS directly (no decoding). To prevent noise, you need to
make digital connections (Refer to pages 20, 21) and set SIGNAL SELECT
to "DIGITAL",
When playing LD recorded in Dolby Digital
When connecting a DVD/LD player or LD player using the AC-3 RF output, a commercially available RF demodulator
(RFD-1) is required. The RF demodulator changes the RF signal to a digital signal which is then processed by the
receiver at the digital input jacks. For more details, refer to the instruction manual supplied with the RFD-I.
Refer to pages 52, 53 for Dolby Digital, Dolby Pro Logic, and DTS.
30
<ARB7157>