Philips TEA5880TS Manual
Philips TEA5880TS Manual

Philips TEA5880TS Manual

Integrated fm stereo radio ic for host processor tuning in handheld pplications

Advertisement

Quick Links

1. General description

2. Features

TEA5880TS
Integrated FM stereo radio IC for host processor tuning in
handheld applications
Rev. 02 — 26 April 2004
The TEA5880TS stereo FM radio IC dramatically reduces the printed-circuit board area
2
(only 100 mm
) needed to integrate FM radio functionality into portable devices. This
makes it invaluable for any application where space is at a premium.
Relying on a system host processor for radio tuning, the TEA5880TS is ideally suited for
powerful devices such as PDAs, notebooks, portable CD and MP3 players.
No alignments necessary
Complete adjustment-free stereo decoder; no external crystal required
Fully integrated MPX VCO circuit
Fully integrated low IF selectivity and demodulation
The full integration level means no or few external components required
No external FM discriminator needed due to full integration
Built-in adjacent channel interference total reduction (no 114 kHz, no 190 kHz)
The level of the incoming signal at which the radio must lock is software programmable
Due to new tuning concept, the tuning is independent of the channel spacing
Very high sensitivity due to integrated low noise RF input amplifier
RF Automatic Gain Control (AGC) circuit
Standby mode for power-down, no power switch circuitry required
2.7 V minimum supply voltage
MPX output for RDS
3-wire bus
In combination with the host, fast, low power operation of preset mode, manual search,
automatic search and automatic store are possible
Host can be in Sleep mode after tuning; a minute retuning is recommended to
compensate for temperature and voltage fluctuations
Covers all Japanese, European and US bands.
Preliminary data sheet

Advertisement

Table of Contents
loading

Summary of Contents for Philips TEA5880TS

  • Page 1: General Description

    ) needed to integrate FM radio functionality into portable devices. This makes it invaluable for any application where space is at a premium. Relying on a system host processor for radio tuning, the TEA5880TS is ideally suited for powerful devices such as PDAs, notebooks, portable CD and MP3 players.
  • Page 2: Quick Reference Data

    = 68.5 kHz and pilot left = 0 or f = 68.5 kHz and f right right left 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004 2 of 27...
  • Page 3: Ordering Information

    Description Version TEA5880TS SSOP24 plastic shrink small outline package; 24 leads; body width 5.3 mm SOT340-1 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004 3 of 27...
  • Page 4: Block Diagram

    Depending on the antenna design the filter components at pins 1 and 2 may not be necessary. The only two remaining coils connected to pin 17 to 20 can be replaced by printed-circuit board traces that will fit underneath the TEA5880TS resulting in a design without any external components;...
  • Page 5 LEVEL VOLTAGE GENERATOR AUDL RFIN QUADRATURE STEREO DE-EMPHASIS DE-EMPHASIS SELECTIVITY DEMODULATOR MIXER MIXER DECODER 50/75 s 15 kHz RFGND AUDR TEA5880TS POWER STABILISATOR SWITCH 3, 13, 24 14, 15, 16, 22, 23 001aaa666 n.c. Fig 2. Block diagram (no external components).
  • Page 6: Pinning Information

    9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004 6 of 27...
  • Page 7: Functional Description

    The IF counter outputs a 16-bit count result via the data line. 7.7 Mute The digital interface controls the audio mute and output level. 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004 7 of 27...
  • Page 8: Stereo Decoder

    8. Digital interface (3-wire bus) The TEA5880TS has a 3-wire bus with read/write, clock and data line. The register set of the TEA5880TS can be accessed via the digital interface. The pins given in Table 4 are defined for the digital interface of the TEA5880TS.
  • Page 9: Register Description

    32 011b count 128 100b count 512 101b count 2048 110b count 8192 111b count 32768 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004 9 of 27...
  • Page 10 11-bit digital-to-analog converter for adjusting the stereo decoder clock The frequency is decreased when increasing the content of this register. 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004...
  • Page 11 64 values caused when FC[7:6] = 01b or 10b) The frequency is decreased when increasing the content of this register (more capacitors). 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004...
  • Page 12 7 bits set = > 70 dB V not applicable; always read as logic 1 7 to 5 R[2:0] chip revision; the revision for TEA5880TS is 100b 4 to 3 not applicable; always read as logic 1 reserved for production test not applicable;...
  • Page 13: Accessing The Tea5880Ts

    Integrated FM stereo radio IC for host processor tuning 8.2 Accessing the TEA5880TS Access to the TEA5880TS can be achieved via the 3-wire bus. At the host side, the R/W and CLOCK are output signals, while the DATA signal is bidirectional.
  • Page 14: Reading From The Tea5880Ts

    2. Enable measure mode (clear EN_MEAS# bit of control register A) 3. Reset the counter (control register B, CNT_RST bit, pulse HIGH-to-LOW transition) 4. Start the counter on the TEA5880TS (control register B, set CNT1_EN bit); at the moment the R/W signal goes LOW the counter starts 5.
  • Page 15: Initialize The Tea5880Ts

    = 32 ms. In the application care should be taken to have an accurate measuring window t. 8.6 Initialize the TEA5880TS After power-up, the TEA5880TS needs to be initialized as follows: • Control register A: STE_PMUTE = 1; DEM_PMUTE = 1; AMUTE = 1; FM = 1; other bits = 0 •...
  • Page 16 8 ms to 100 ms disable 16-bit counter enable PISO at output source 001aaa671 Fig 7. Measuring sequence. 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004 16 of 27...
  • Page 17: Limiting Values

    LOW-level output voltage = 500 A Timing clock input clock HIGH time CLK(H) clock LOW time CLK(L) 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004 17 of 27...
  • Page 18: Components List

    THD = 30 %. Fig 9. Total harmonic distortion. 13. Components list No external components necessary. 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004 18 of 27...
  • Page 19: Printed-Circuit Board Layout For Ssop24 Package

    (2) Pins 14, 15, 16, 21, 22 and 23 are not connected. Fig 10. Printed-circuit board layout. 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004 19 of 27...
  • Page 20: Application Information

    100 nF (1) TEA5880FM 100 nF (1) DATA CLOCK AUDL AUDR 001aaa672 (1) optional. Fig 11. Application diagram. 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004 20 of 27...
  • Page 21: Package Outline

    OUTLINE EUROPEAN ISSUE DATE VERSION PROJECTION JEDEC JEITA 99-12-27 SOT340-1 MO-150 03-02-19 Fig 12. Package outline. 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004 21 of 27...
  • Page 22: Soldering

    – larger than or equal to 1.27 mm, the footprint longitudinal axis is preferred to be parallel to the transport direction of the printed-circuit board; 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004...
  • Page 23: Manual Soldering

    For more detailed information on the BGA packages refer to the (LF)BGA Application Note (AN01026); order a copy from your Philips Semiconductors sales office. All surface mount (SMD) packages are moisture sensitive. Depending upon the moisture content, the...
  • Page 24 The appropriate soldering profile can be provided on request. Hot bar soldering or manual soldering is suitable for PMFP packages. 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004...
  • Page 25: Revision History

    Data sheet status Change notice Order number Supersedes TEA5880_2 20040426 Preliminary data sheet 9397 750 13022 9397 750 13022 © Koninklijke Philips Electronics N.V. 2004. All rights reserved. Preliminary data sheet Rev. 02 — 26 April 2004 25 of 27...
  • Page 26: Data Sheet Status

    This data sheet contains data from the preliminary specification. Supplementary data will be published at a later date. Philips Semiconductors reserves the right to change the specification without notice, in order to improve the design and supply the best possible product.
  • Page 27: Table Of Contents

    Accessing the TEA5880TS....13 Writing to the TEA5880TS ....13 Reading from the TEA5880TS ... . 14 Measuring frequency with the TEA5880TS .

Table of Contents