Payne PG9MAA Specification page 5

SPECIFICATIONS Continued
UN,TS,ZE [ 048080 L 080080 L 048100 L 080100 L 0801=0 L 080140
RATINGS AND PERFORMANCE
Input Btuh* 80,000 80,000 100,000 100,000 120,000
Output Capacity1- Nonweatherized ICS 74:000 74:000 83,000 83,000 112:000
AFUE%t Upflow/Horizontal Direct Vent Applications 92.1 92.1 92 1 92 1 92 1
Nonweatherized iCS Downflow Direct Vent Applications 91.5 91.5 91.5 91 5 91 5
Upflow/Horizontal Non-Direct Vent Applications 90.0 90.0 900 900 900
Downflow Non-Direct Vent Applications 90.0 90.0 900 900 90.0
Certified Temperature Rise Range °F
Certified External Static Pressure
Airflow CFM_:
Heating
Cooling
Heating
Cooling
ELECTRICAL
Unit Volts--Hertz--Phase
Operating Voltage Range Min--Max**
Maximum Unit Amps
Unit Ampacityl-1-
Minimum Wire Size
Maximum Wire Length (Ft)$_:
Maximum Fuse Size or Ckt Bkr Amps (Time-Delay Type Recommended)
Transformer (24v)
External Controt Heating
Power Available Cooling
Air Conditioning Blower Relay
CONTROLS
Limit Control
Heating Btower Controt (Off Delay)
Burners (Monoport)
Gas Connection Size
GAS CONTROLS
Gas Valve (Redundant)
Manufacturer
Minimum Intet Pressure (In wc)
Maximum inlet Pressure (In wc)
30--60
015
0.50
1285
1525
20--50
015
0.50
1785
1925/2035
45--75
0.20
050
1315
1570
30--60
0.20
050
1690
1930/2130
40--70
020
0.50
1720
2000/2130
138,000
127,000
92.1/92.0
90.0
N/A
N/A
50--80
020
0.50
1970
1990/2045
Ignition Device
BLOWER DATA
Direct-Drive Motor H P (Permanent Sprit Capacitor) 112t3/4tl/2t3/4t3/4t3/4
Motor Fult Load Amps 7.9 11 1 7 9 11.1 11.1 11 1
RPM (Nominal)--Speeds 1075--4
Blower Wheel Diameter x Width (tn.) 11X8 L 11X10 L 11X8 L 11X10 t 11X10 L 11X10
Filter Size (In.)--Permanent Washable (1) 20 X 25 X 1 (1) 24 X 25 X 1
FACTORY-AUTHORIZED AND LISTED, DEALER-INSTALLED OPTIONS
Gas Conversion Kit--Natural-to-Propane KGANP3001ALL*
Gas Conversion Kit--Propane-to-Natural KGAPN2301ALL
Twinning Kit KGATW0601HSl L N/A
Manufactured (Mobile) Home Kit1-1-1- KGAMH0101KIT / N/A
Downflow Base*** KGASB0201ALL
Vent Termination Kit (Bracket Only for 2 Pipes)l-t-I- 2-in --KGAVT0101BRA 3-in.--KGAVT0201BRA
Concentric Vent Termination Kit (Singte Exit)l-l-I- 2-in.--KGAVT0501CVT 3-in.--KGAVT0601CVT
Condensate Freeze Protection Kit KGAHT0101CFP
Side Filter Rack (Without Filter)--Upflow ON LY KGAFR0206ALL
Thermostat_Programmabie For Use With Air Conditioner--TSTATPPSAC01
Thermostat_Non-Programmable For Use With Air Conditioner--TSTATPPBAC01-B
Condensate Neutralizer Kit (obtained thru RCD) P908-0001
115--60--1
104--127
102 14.8
13.5 19.3
14 12
27 30
15 20
40va
12va
21va
Standard
SPST
Selectable 90, 120, 150, or 180
4
L
4
L 5 L 5 L 8 L 8
1/2qn. NPT
White-Rodgers
45 (Natural Gas)
13.6 (Natural Gas)
Hot Surface
* Gas input ratings are certified for elevations to 2000 ft. For elevations above 2000 ft, reduce ratings 2 percent for each 1000 ft above sea level. In Canada,
derate the unit 5 percent from 2000 to 4500 ft above sea level.
1- Capacity and AFUE in accordance with U.S. Government DOE test procedures.
_: Airflow shown is for bottom only return-air supply. For air delivery above I800 CFM, see Air Delivery table for other options. A filter is required for each
return-air supply.
** Permissible voltage limits for proper furnace operation.
1-1- Unit ampaeity = 125 percent of full load amps of largest components plus 100 percent full load amps of all other potential operating components (EAC, humidi-
tier, etc.).
$_: Length shown is measured 1 way along wire path between unit and service panel for maximum 2 percent voltage drop.
*** Required for installation on combustible floors when no coil box is used, or when any coil box other than a Payne CD5, CK5 or KCAKC cased coi! is used.
1-11- For direct vent applications only.
N/A--Not Applicable. Unit is not allowed in this installation application.
ICS--Isotated Combustion System
--5--
101 141 14.6 146
134 184 19.1 188
14 12 12 12
28 31 30 30
15 20 20 20