Troubleshooting - Orien FS50OD User Manual

Troubleshooting
Before Calling for Service
If the unit appears to be malfunctioning, read through the OPERATION section of this manual
first. If the problem persists, check the Troubleshooting Guide below and on the following page.
The problem could be something very simple that can be solved without a service call.
Troubleshooting Guide
Problem Possible Cause Probable Correction
The icemaker is unplugged. Plug the ice maker in.
Replace fuse - if this happens, call
The fuse is blown, for service to check for a short
The machine circuit in the ice maker.
doesn't operate. Turn the Power switch to ON.
Remove some ice, making sure the
ice-full probe is free of ice.
Turn on the water supply tap.
The water doesn't
feed in after the
machine starts. Reconnect the water supply line.
Clean the condenser.
Check the installation.
Machine makes ice,
but ice storage bin
does not fill up with
ice.
Water is leaking
from the unit.
The Power switch is set at
OFF.
The ice storage bin is full of
ice.
The water supply tap is
turned off.
The water supply line is not
properly connected.
Condenser may be dirty.
The air flow to the ice maker
may be obstructed.
The ambient temperature and
water temperature are high,
or machine is near some heat
source.
A few water drops fall to the
floor when you open the
door to take out ice from
storage bin.
Water supply connection
leaking.
Check the installation.
Normal condensation on the door or
some water together with ice. Take
care when you take out ice.
Tighten fitting. See "Connecting the
Water Line".
25