Table of Contents
Advertisement
ASSEMBLY
Assembly requires two persons.
Set the incline trainer in a cleared area and remove all packing materials, Do
not dispose
of the packing materials
until assembly
is completed.
Note: The underside of the incline trainer
walking belt is coated with high-performance
lubricant, During shipping, some lubricant may be transferred to the
top of the walking belt or the shipping carton, This is normal and does not affect incline trainer performance, if
there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive
cleaner.
Assembly requires the included hex_
and your own Phillips screwdriver
_
and
adjustable
wrench
_.
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses
is the quantity needed for assembly. Note: If a part is not in the hardware
kit, check to see if it is preattached
to one of the parts to be assembled.
To avoid damaging
plastic parts, do not use power tools for assem-
bly. Extra hardware
may be included.
3/8" Nut (8)-2
1/4" x 1"
Bolt (32)-4
3/8" Star
#8 x 1/2" Cover
#8 x 3/4"
#8 x 1" Tek
Washer (9)-6
Screw (92)-2
Screw (1)-8
Screw (2)-4
5/16" x 3/4"
Bolt (6)-4
\
3/8" x 2 1/2" Bolt (4)-2
3/8" x 3 1/2" Bolt (3)-4
3/8" x 5" Bolt (7)-2
Hide quick links:
Advertisement
Table of Contents
