Table of Contents
Advertisement
BURNER
VALVE / REGULATOR
The burner control operates in the following positions indicated by the pointer at the top of the
regulator as installed on the grill:
•
OFF - This stops the flow of gas to the burner.
•
PUSH TO TURN ON - Push "IN" on the knob to release the knob from the locked "OFF"
position.
•
HIGH - This position provides the highest gas flow and the hottest cooking temperatures.
•
MED - This position provides cooking temperatures between HIGH and LOW.
•
LOW - This position provides the lowest cooking temperatures.
COOKING TEMPERATURE
SETTINGS
•
HIGH - Approximately 450 F
•
MED- Approximately 400F
•
LOW-
Approximately 350F
Note: A disposable 1 lb. propane cylinder "NEAR EMPTY" can significantly reduce internal
pressure and may affect the regulator's capability to accurately control gas flow. As the
propane cylinder reaches empty, this may cause "hotter-than-normal"
cooking temperatures
during the final minutes of use.
Note: A disposable 1 lb. propane cylinder will provide approximately 4-6 hours of cooking time
with the Perfect Flame Table Top Grill.
LIGHTING
THE GRILL
1. Make sure the regulator is properly secured into the
burner end.
2. Make sure the propane cylinder is tightly treaded into
the regulator (hand tighten only).
3. Place the legs in the extended position as shown in Fig. 4.
4. Open lid. Always open lid when lighting.
5. Locate the lighting rod (4-1) on the right side of the
grill as shown in fig. 5. Insert a match through the access
hole (4-2) next to the burner tube. Keep flame next to the
burner while actuating the gas control knob on the regulator.
6. Push the gas burner control knob "IN" and turn the control knob counterclockwise
to the
"lighting Position" while watching burner flame
7. If ignition does not occur in 3-5 seconds, turn the control knob "OFF". Wait 5 minutes before
attempting to re-light the grill. If the grill fails to ignite after the second attempt, call customer
service at 1-800-913-8999 for assistance
8. With burner lit, gently close the lid and allow the grill to warm up for 20-30 minutes prior to
use. Note:
If the burner
should
go out for any reason,
turn the control
knob
to
the
"OFF"
position.
Wait 5 minutes
before
attempting
to re-light.
(4-2)
Fig. 4
(4-1)
Visually
check
the burner
flames
prior to
each
use. The flames
should
look like
this picture;
if they do not ,refer to the
burner
maintenance
part of this manual.
Advertisement
Table of Contents
