Fisher & Paykel Aerotech OD302 User Manual page 39

Using the Self Clean mode
Remove oven shelves, shelf supports (see 'Cleaning') and all other cookware/utensils from the
1
oven before using the Self Clean mode.
Select the Self Clean mode by turning the oven mode dial.
2
Select the maximum temperature using the temperature dial,
3
and this will change to
will show in the clock display and the time remaining will count down.
For your safety the door lock will automatically activate once the Self Clean mode and
temperature has been selected.
At the end of a self clean cycle, the door will unlock and the
4
CLEAN
disappear. The
display until the oven is returned to manual operation - To do this turn the oven mode and
temperature dials to 'OFF' .
At the completion of the self clean cycle, you will notice grey ash deposited inside the oven.
5
The amount of ash in the oven is dependent on the amount of soil present in the oven before
it was cleaned. When the oven is completely cooled, the ash is easily removed with a small
brush or dry cloth, then wipe out the oven with a clean damp cloth and dry with a clean
lint-free cloth.
Replace the shelf supports (see 'Cleaning') and oven shelves.
6
To cancel the Self Clean mode before it has finished
Turn the oven mode and temperature dials to 'OFF' .
display and the door will remain locked until the oven has cooled to a safe temperature.
Do not turn the power to the appliance off as the fans are necessary to cool the oven.
If the oven is cool or below the safe temperature it will return to normal operation and the
clock display will show the time of day.
Short Self Clean cycle
A shorter self clean cycle can be selected if the oven is only lightly soiled:
Select the Self Clean mode by turning the oven mode dial.
1
Select the maximum temperature using the temperature dial.
2
While is shown in the display, press the
3
and the colon will flash.
Rotate the Setting Selector
4
and three hours.
Press the button again or wait eight seconds to adopt the setting and start the self clean
5
cycle. The clock display will show the time remaining.
when the cycle begins. The
symbol and will flash in the clock display and
dial to reduce the time; this can be anywhere between two
will appear in the display
DOOR LOCK
DOOR LOCK
will appear in the oven mode
COOK TIME
button. The
and CLEAN symbols
symbol will
in the mode
AUTO
and symbols
37