Attaching The Handle - MTD Series 020 Operator's Manual

ATTACHING THE HANDLE
1. Removethe hairpinclips from the handlebrackets
and removethe carriagescrewsand wingnuts from
the lowerhandle.
a. Placethe bottomholesin lowerhandle(notch
pointingdown)over the pinson the handle
bracketsand securewith hairpinclips. See
Figure3-2.
b. insertcarriagescrewsthroughupperhole in
lowerhandlefrom the inside and securewith
wing nuts.See Figure3-2.
2. a. Unfoldthe upperhandleuntilit alignswith lower
handle.Makesurethe rope guide ison the right
side of upper handle.See Figure3-3.
iMPORTANT:Makesurethe cablesare routedoutside
the lowerhandle.Also, do not crimp thecables while
lifting up the handles.
f
\
Figure3-2
........
.
b. Securethetwo handlesby tighteningthe star
knobs (carriagebolts mustbe seatedproperly
into the handle).See Figure3-3.
Loosenthe wingnut that securesthe ropeguide to
the rightside of upperhandle.
a. Pullthe starterrope out of theengine slowly.
See Figure3-4.
b. Slip the starter ropeintothe ropeguide.
c. Tightenthe wingnut. See Figure3-4.
Figure3-3
Figure3-4
7
upyo,.,
Chipper
Shredder
IMPORTANT
Make sure the cables
are routedoutside the
lower handle. Also do
not crimp the cables
while lifting up the
handles.