Table of Contents
Advertisement
Dlease
make these simple
. checks before callingfor
service.
These tips can save you
time and money since charges for
TV installation
and adjustment
of
c:_stomer controls are not
covered
under your warranty.
No Power
No Picture
No Sound
Remote Does Not
Work
TV Displays Wron
Channel
or No
Channels
Above 13
CAUTION:
A video source (such as a video game, Compact
Disc Interactive
- CDI, or
TV information
channel)
which shows a constant
non-moving
pattern on the TV screen,
can cause picture tube damage.
When your TV is continuou_Jy
used with such a source
the pattern of the non-moving
portion of the game (CDI, e::c.)could
leave arl image
permanently
on the picture tube.
When not in use, turn the video source OFF.
i Regularly
alternate
the use of such video sources with normal "IV viewing.
, Check the TV power cord.
Unplug the TV, wait 1 minute, then reinsert plug into outlet
and push POWER
button again.
I
• Check to be sure outlet is not on a wall switch.
Check antenna connections on the rear of the TV. Are they properly secured to the
antenna plug on the "IV?
Check the CABLE CHANNEL TUNING control for correct position.
Check PICTURE SOURCE control for correct position. VCR/AUX1 or AUX2
position without a signal source will result in a blank screen.
Check the VOLUME
buttons.
Check the MUTE button on the remote control.
Check the INTERNAL
"IV SPEAKER
ON/OFF
control for the correct position.
If attempting
auxiliary
equipment
hook-ups,
check audio jack connections;
and that the
auxiliary
equipment
is on and in the proper operating
modes.
Check TV-VCR-CBL
"'System"
buttons on the remote.
Press the remote's
T___V.
System
button to send commands
to the TV.
Check batteries.
Replace
with 9-Volt Heavy Duty (Zinc Chloride) or Alkaline
batteries
if necessary.
Clean the remote and the remote sensor window on the "Ix, ' .
r Repeat channel selection,
i
• Add desired channel
numbers
(ADD/DELETE
CHANNELS
control)
into TV memory.
• Check CABLE
CHANNEL
TUNING
control for correct position.
This "IV is equipped with protective circuitry that shuts the TV off in case of moderate
power surges. Should this occur turn the: TV back on by pxessing the POWER button
once or twice, or unplug and then replug the power cord at the AC outlet.
This feature is NOT designed to prevent damage due to nigh power surge,'; such as those
caused by lightning, which is not covered by your warranty.
Cleanin_
and Care
• To avoid possible
shock hazard be sure the TV is unplugged
from the electrical
outlet before ,.'leaning.
• When cleaning
the TV screen take care not to scratch or damage
the screen surface (avoid wearing jewelry
or using
anything
abrasive-
do not use household
cleaners).
Wipe the front screen with a clean cloth dampened
with water.
Use
even, easy, vertical
strokes when cleaning.
• Specially
designed
screen cleaning
kits are also available which contain
anti-static
cleaners_ and brushes designed
to get
into the ridges of the TV screen. If interested,
ask your dealer about the SBS4100
Projection
"W Screen Cleaning
Kit or
call our toll-free
Accessory
Parts ordering
number
1-800-292-6066.
• Gently wipe the cabinet
surfaces with a clean cloth or sponge dampened
in a solution of cool clear water and a mild soap
or detergent.
Use a clean dry cloth to dry the wiped surfaces.
• Occasionally
vacuum
the ventilation
holes or slots in the cabinet back.
• Never use thinners,
insecticide
sprays, or other chemicals
on or near the cabinet,
as they might cause permanent
marring
of the cabinet
finish.
57
Advertisement
Table of Contents
