Table of Contents
Advertisement
m
.Vour
TV remote can be set to
&work
your Cable Converter by
what is called the SEARCH
method.
If the "REMOTE CODE" number
method shown in the previous
section did not set your remote to
work your Converter, then follow
:he five easy :rteps listed below.
Please read t,_rough steps 1-5
before beginning.
_>
Press the POWER
button on
]the Converter to turn Converter
,ON.
_
Stand at least six feet away from
the front of the Converter.
Point the remote toward the
Converter.
HOLD DOWN the A/CH and
CBL System buttons at the same
time. KEEP ttOLDING
BUTI'ONS EK)WN.
_>
Watch the Channel Indicator
on the Converter.
Channel Numbers will SCAN UP
when the Converter has been
identified. This may take up to two
minutes.
_>
Release the A/CH and CBL
System buttons as soon as channel
numbers start: to scan up. The
Converter c_'le has been identified
and the remote is ready to operate
the Converter.
_[_f--_.-_
Remember. A minute or
_1_ two can seem very long, but
the code should be located within
two minutes.
Don't let the Converter scan up
more than five channels. If you do
the remote may pass up the right
code and another two minute
search cycle will have to be
repeated.
If no channel change happens
within two minutes, repeat steps 1-
5. Should a channel change still
not occur, the:remote will not work
with the desired Converter.
Cable Converter
09
Don't
let the Converter
man
up more
than five channels
(in Search
mode).
49
Six Feet
(minimum)
,1
Advertisement
Table of Contents
