Philips 46PP9302 Directions For Use Manual page 19

Nd w that you have looked up the./bur-
igit remote-control Direct-entJ T Code
/or your brand q/accessory device, you are
read), to .follow the simple steps shown below
to program your "l'Vremote.
Please read through all the steps beJbre
beginning.
1
2
First, press and hold down the VCR
or ACC (for an accessory device
other than a VCR) mode button on
the TV remote, Then press and hold
down the MENUTSELECT button at
the same time for a brief moment,
Release the buttons, The TV remote
back light will switch on,
NOTE: For correct operation, you
must first press and hold the mode
butlon and then press and hold the
MEN U/SELECT button simultaneously.
Within 30 seconds of pressing the
VCR (or ACC) button and
MENU/SELECT button, enter a
four-digit code for the accessory
device (see pages 21 and 22),
if you make a mistake while atlempt-
ing to enler the four-digit code and
want io start again, press any button
other than one with a number, Then
relurn to step I to begin again.
Point the remote at the accessory device. Then press the POWER but-
ton on the remote to turn the device
on,
If you do not enter a complete code within
30 seconds, you will need to perform step
1 of the Code-entry Method again.
If you enter more than four digits, the unit
will retain the first four digits entered.
If the procedure explained above does not
work the first time, repeat the steps using
the same remote code number.
• If after a second try the remote does not
operate your accessory device, and more
code numbers are listed for your brand,
use the next lisled code number.
• If after repeated attempts the Entry-code
Method does not allow you to work your
accessory device with your TV remole, try
the Search Method explained on the next
page,
19
Using the Remote Control
Satelli'te Receiver
Cable Converter Box
DVD Player
Immim_l Immnmnm I
VCR
®®®
®®®
®®®
®®®
PHILIPS