Timer Recording - Philips CCB193AT Owner's Manual

32 Timer R ecording
Follow the steps below to program the TVNCR to record'iV pro-
grams while you're away from home.The TV/VCR will turn itself
on, record, and turn itself off automatically. Before you begin, make
sure:
• The clock is set. If not, CLOCK. MUST BE SET appears, fol-
lowed by the SET CLOCK. menu.
• Channels are set up.
There is a tape in theTV/VCR. (Make sure the tape's record tab
is intact and the tape is long enough to record the program.)
Complete each step within 60 seconds of completing the
previous step. If you don't, you may start again at step I.
I
Press the MENU button.
i L t
I VC R pROGRAM '
VCR SETUP
CAPTmN
i REM;NDER
BRIGHTNESS
2
Press the PLAY/A button or the STOP/Y button to select
VCR PROGRAM, then press the F.FWD/_ button.
CDG ] 0
[D CD
3 --
Q0 0_ PoL
VCRPROGRAM
• ONCE
DAILY(MON-FRI)
WEEKLY
PROGRAi_I REVIEW
SELECT &V CHOOSE I_
TO END PRESS EXIT
J
3
Press the PLAY/A button or the STOPIY button to select
a ONCE, DAILY, ORWEEKLY recording.Then, press the
F.FWD/I_ button.
• ONCE: The TV/VCR will record aTV program on any day you
choose, up to 12 months away.
• DAILY: The TV/VCR will record every day from Monday to
Friday - starting at the same time and recording the same channel
for the same length of time.
• WEEKLY: The TV/VCR will record the same channel on the
same day, at the same time, and for the same length of time
every week.
Daily PROGRAM -i _3_s 67s
Recording
(example)
SELECT PROGRAM NUMBER
END PRESSEXIT
Helpfql Hints
With ShowGuard, you don't have to
worry about losing your timer
recordings. If the power fails, pro-
grammed timer recordings will be
restored when the clock is reset.
(The clock will reset itself automati-
cally if you are using the AUTO
CLOCK feature. Details are on
pages 14-17. If you are not using
the AUTO CLOCK feature, reset the
clock manually. Details are on pages
12-13.) The timer recording will not
occur only if the timer recording was
scheduled to take place during the
power failure.
Youcannot set a timer recording if
DEFEAT RECORDING is set to ON.
Details are on page 36.