Add Gasoline; Connect Hose And Water Supply To Pump; Add Gasoline To Fuel Tank; Connect High Pressure Hose To Spray Gun - Generac Portable Products 2500PSI Owner's Manual

Generac Portable P roducts 2,500 PSI H igh Pressure Washer
NOTE: Check oil often during engine break-in. Refer to
engine owner's manual for recommendations.
==m=q IM =ml Ee_ra
Add Gasoline
_ WARNING! Never fill fuel tank indoors. Never
fill fuel tank when engine is running or hot. Do Not
smoke when filling fuel tank.
_ WARNING! Never fill fuel tank completely full.
Provide spacefor fuel expansion.Wipe away anyfuel
spillagefrom engine and equipment before starting.
• Use fresh, clean unleadedautomotive gasolineand store in
approved, clean, covered containers. Use clean fill
funnels. Never use "stale" gasoline left over from last
season or gasoline stored for long periods.
• Clean area around fuel fill cap, remove cap.
• Slowly add gasoline to fuel tank. Use a funnel to prevent
spillage. Fill tank to "Maximum Fuel Level" (Figure 8).
Connect high
pressure hose
here.
Attach the other end of the high pressure hose to the
high pressure outlet on the pump (Figure 10). Pull down
on the collar of the quick connect, slide fitting into the
pump and let go of collar. Pull on hose to be sure of a
tight connection.
_ Maximum Fuel Level
Install fuel cap and wipe up any spilled gasoline.
Connect Hose and Water Supply to
Pump
IMPORTANT: You must assemblethe nozzle extension
and attach all hoses before you start the engine. Starting
engine without all hoses connected and water supplied will
damagethe pump.
• Uncoil high pressure hose and attach quick connect end of
hose to the baseof the spray gun (Figure 9). Pull down on
the collar of the quick connect, slide onto the gun and let
go of collar. Tugon hose to be sure of a tight connection.
• Before you connect your garden hose to the water inlet,
inspectthe inlet screen (Figure I I). Clean the screen if it
contains debris, replace it if it isdamaged. DO NOT
RUN THE PRESSURE WASHER IF THE SCREEN IS
DAMAGED. NEVER SIPHON INLET WATER.
• Run water through the garden hose for 30 seconds to
clean out any debris. Turn off water.
• Connect the garden hose to the water inlet. Tighten by
hand (Figure II).
/
7