Add Engine Oil; Attach Handle To Base; Secure Handle And Clip; Secure Handle - Generac Portable Products 2500PSI Owner's Manual

Generac Portable P roducts 2,500 PSI High Pressure Washer
• Secure tray to handle with self tapping screws using a
#2 phillips screwdriver. Ensurescrews are tight but not
crushing the plastic accessory tray.
• Placethe handle assembly onto the handle supports
connected to the main unit. Make sure the holes in the
handle align with the holes on the handle supports
(Figure 2).
Atig
Handle
Supports
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
• Insert the carriage bolt through the right side hole from
the outside of the unit. Slide the spring clip up the
chemical hose and slide it onto the carriage bolt. Attach
a plastic knob from the inside of the unit. Tighten by
hand (Figure 3).
• Pinch the chemical hose and slide it into the metal clip as
shown in Figure 6.
• Tilt the unit up by the handle and attach the metal clip to
the rib on the center underside of the accessory tray
(Figure 7). Slide the chemical hose through the metal clip
so that it is tight but not kinked.
• Insert the carriage bolt through the left side hole from
the outside of the unit and attach a plastic knob from the
inside of the unit (viewing unit from the rear). Tighten by
hand (Figure 4).
o
• Insert the "J" hook into the second from the left slot in
the accessory tray (Figure 5).
Add Engine Oil
IMPORTANT: Any
attempt
to crank or start the engine
before it hasbeen properly servicedwith the
recommendedoil may result in an enginefailure.
• Place pressure washer on a level surface.
• Refer to the engine owners manual to add recommended
oil to engine.
/
6