Add Gasoline; Add Engine Oil; Connect Hose And Water Supply To Pump - Generac Portable Products 1539-0 Owner's Manual

• Secure handle to the pressure washer using the four
provided flange nuts.
• Slowly tip the pressure washer back in place and insert
the multi–colored nozzles in the spaces provided in the
handle.
Install Oil Dipstick on Pump
CAUTION!
You MUST remove the pump's shipping cap
and install the oil dipstick. Failure to do so will void the
warranty and damage the pump.
To install the oil dipstick:
• Make sure your unit is on a level surface.
• Remove and discard the shipping cap located on the
pump (Figure 2).
Figure 2 — Install Oil Dipstick onto the Pump
Remove shipping cap and
install oil dipstick here.
Pump Oil
Dipstick
• Install the oil dipstick.
NOTE: The pump is pre-lubricated and sealed, requiring
no additional lubrication for the life of the pump.

Add Engine Oil

IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
Generac Portable Products 3,000 PSI High Pressure Washer
Shipping Cap
• Place pressure washer on a level surface.
• Refer to the engine owners manual to add recommended
oil to engine.
NOTE: Check oil often during engine break–in. Refer to
engine owner's manual for recommendations.

Add Gasoline

WARNING!
fill fuel tank when engine is running or hot. Do Not
smoke when filling fuel tank.
WARNING!
Provide space for fuel expansion. Wipe away any
fuel spillage from engine and equipment before
starting.
• Use clean regular unleaded fuel and store in approved
clean covered containers. Use clean fill funnels. Never
use "stale" gasoline left over from last season or gasoline
stored for long periods.
• Clean the area around the fuel fill cap, remove the cap.
Slowly fill tank to the bottom of the filler neck (Figure 3).
Figure 3 — Add Gasoline to Fuel Tank
• Install the fuel cap and wipe up any spilled gasoline.
Connect Hose and Water Supply to
Pump
IMPORTANT: You must assemble the nozzle extension
to the spray gun and attach all hoses before you start the
engine. Starting engine without all hoses connected and
water supplied will damage the pump.
• Uncoil high pressure hose and attach quick connect end
of hose to the base of the spray gun (Figure 4). Pull
down on the collar of the quick connect, slide onto the
spray gun and let go of collar. Tug on hose to be sure of
a tight connection.
6
Never fill fuel tank indoors. Never
Never fill fuel tank completely full.
Maximum Fuel Level