Add Engine Oil; Add Gasoline - Generac Portable Products 2300PSI 1674-0 Owner's Manual

b
Y_&_ $_ra_on'
_ powE_ e_ODUCT_
* Phce the hande onto the hande supports aHready
connected to the main unit. Make sure the holes in the
hande aHign with the holies on the hande supports
(Figure 2).
NOTE: It may be necessary to move the handHe supports
from side to side in order to aHign the hande so it will sHide
over the handHe supports.
° Insert the carriage boHt through the holies from the
outside of the unit and attach a phstic knob from the
inside of the unit.Tighten by hand (Figure 3).
G
, insert the "J" hook into the second from the left slot in
the accessory tray (Figure 4).
J
* Pinch the chemical hose that comes out of a hole in the
unit's base and slide it into the metal clip_ as shown in
Figure 5.
* Tilt the unit up by the handle and attach the metal clip to
the rib on the left underside of the accessory tray
(Figure 6). Slide the chemical hose through the metal clip
so that it is tight but not kinked.
Add
Engine Oil
JNPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
* Place pressure washer on a [eve[ surface.
° Refer to the engine owners manual to add recommended
oil to engine.
NOTE: Check oil often during engine break-in. Refer to
engine owner's manual for recommendations.
Add Gasoline
WARNING!
Never fill fuel tank indoors. Never
fi[[ fuel tank when engine is running or hot. Do Not
smoke when filling fuel tank.
WARNING! Never fill fuel tank completely full.
Provide space for fuel expansion.Wipe away any fuel
spillage from engine and equipment before starting.
6