Add Engine Oil - Generac Portable Products 2500PSI Owner's Manual

• Secure tray to handle with self tapping screws using a
#2 phillips screwdriver. Ensure screws are tight but not
crushing the plastic accessory tray.
• Place the handle assembly onto the handle supports
connected to the main unit. Make sure the holes in the
handle align with the holes on the handle supports
(Figure 2).
Figure 2 — Attach Handle to Base
Align Holes
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
• Insert the carriage bolt through the right side hole from
the outside of the unit. Slide the spring clip up the
chemical hose and slide it onto the carriage bolt. Attach
a plastic knob from the inside of the unit. Tighten by
hand (Figure 3).
Figure 3 — Secure Handle and Clip
• Insert the carriage bolt through the left side hole from
the outside of the unit and attach a plastic knob from the
inside of the unit (viewing unit from the rear). Tighten by
hand (Figure 4).
Figure 4 — Secure Handle
• Insert the "J" hook into the second from the left slot in
the accessory tray (Figure 5).
Generac Portable Products 2,500 PSI High Pressure Washer
Handle
Handle
Supports
Figure 5 — Install "J" Hook on Accessory Tray
• Pinch the chemical hose and slide it into the metal clip as
shown in Figure 6.
Figure 6 — Slide Chemical Hose into Metal Clip
• Tilt the unit up by the handle and attach the metal clip to
the rib on the center underside of the accessory tray
(Figure 7). Slide the chemical hose through the metal clip
so that it is tight but not kinked.
Figure 7 — Slide Metal Clip onto Accessory Tray Flange

Add Engine Oil

IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
• Place pressure washer on a level surface.
• Refer to the engine owners manual to add recommended
oil to engine.
6