Before Starting The Generator; To Start The Engine - Generac Power Systems SE10000 Owner's Manual

Hide thumbs Also See for SE10000:
Table of Contents

Advertisement

Generac Portable Products S E10000 G enerator
BEFORE STARTING THE
GENERATOR
Add Engine Oil
For your convenience, an oil filler spout has been
supplied with your generator, This cap fits over a
standard bottle of oil and allows for easy access to the
oil fill
See engine owner's manual for oil recommendations
and fill instructions.
Add Gasoline
,_.
DANGER!
NEVER fill fuel tank indoors
NEVER fill fuel tank when engine is running or
hot. DO NOT light a cigarette or smoke when
filling the fuel tank.
,_)k
DANGER!
Do not overfill the fuel tank. Always
leave room for expansion.
• Use regular UNLEADED gasoline in the generator.
DO NOT use premium gasoline. DO NOT mix oil
with gasoline DO NOT overfill the gas tank.
• Clean area around fuel fill cap; remove cap.
• Fill fuel tank with clean, fresh, unleaded gasoline
Be careful not to overfill. Allow 1/2" of tank space for
fuel expansion (Figure 4).
W_P]T'L_IE_ sltr_ll_a_
_m[_
1/2" Air Space
Tank
• Install fuel cap and wipe up any spilled gasoline.
IMPORTANT: It is important to prevent gum deposits
from forming in essential fuel system parts such as
the carburetor, fuel filter, fuel hose or tank during
storage Also, experience indicates that alcohol-
blended fuels (called gasohol, ethanol or methanol)
can attract moisture, which leads to separation and
formation of acids during storage. Acidic gas can
damage the fuel system of an engine while in storage.
To avoid engine problems, the fuel system should be
emptied before storage of 30 days or longer. See
"Storage" on page 12. Never use engine or carburetor
cleaner products in the fuel tank or permanent
damage may occur.
TO START THE ENGINE
,_.
WARNING!
Never start or stop engine with
electrical devices plugged into the panel
receptacles and turned on. You could damage
both the generator and the electrical devices.
• Unplug all electrical loads from unit's receptacles
before starting the engine.
• Make sure the unit is in a level position.
• Open the fuel shut-off valve (Figure 5).
L
_--FuelTank
• Pull the choke knob to close. If the engine is warm,
or the ambient temperature
is high, pull the choke
knob half-way, or keep it fully open (Figure 6).
Close
/
i
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

1339-0

Table of Contents