Parts Supplied; Cavity Preparation - Fisher & Paykel DishDrawer DD24DT Series Installation Instructions Manual

(2,1) -1- 599632C DD24D TALL installA2 USCA.indd 15/4/09 11:50:45 AM
(2,1) -1- 599632C DD24D TALL installA2 USCA.indd 15/4/09 11:50:45 AM
4

PARTS SUPPLIED

Drain hose Drain hose Wire clip (2)
support (1) joiner (1)
If the Drain hose(s) supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit P/N 525798 which will extend the drain hose(s) by 11' 10" (3.6 m). The kit is available from the nearest
Fisher & Paykel Authorized Service Agent, or Toll free 1.888.936.7872 or www.fisherpaykel.com.

CAVITY PREPARATION

5
Important!
Be sure the edges of the services hole are smooth or covered. If the services
hole is through a metal partition the hole must be protected with the Edge
protector supplied to prevent damage to the power cord or hoses.
These marks indicate mounting bracket screw locations
*
Preferred position. If adequate clearance, services hole can be
higher to clear toekick space.
If hole is higher, ensure drain hose(s) are routed straight into the
waste connection.
Water Connection
Recommended HOT (Maximum 140°F/60°C).
Supplied hose to suit 3/8" (9 mm) male compression fitting.
Water Pressure Max
Water softener models 1 MPa (145 psi)
Other models 1 MPa (145 psi)
Drains will need to be separated to satisfy kosher requirements. We suggest you confirm
acceptability with your local rabbi in respect to kosher installations.
Max. distance of
Left hand Right hand
hoses and cord from
side side
chassis edge
Drain hose
78 ½ " 70 ½ "
(2000 mm) (1800 mm)
Inlet hose
64 ¾ " 49"
(1650 mm) (1250 mm)
Power cord
(excl. plug)
29 ½ " 27 ½ "
(750 mm) (700 mm)
Clamp (1) Side mounting Top
bracket kit mounting
(A and B) (2) brackets (2)
OPTIONAL
If no side partition, use a
brace for securing.
2" x 4"
Min
0.1 MPa (14.5 psi)
0.03 MPa (4.3 psi)
Left hand Right hand
side side
Phillips Washer (1) Moisture protection
16 mm tape (1)
screws (9) (to prevent moisture
damage)
Moisture
3⁄8"
protection
tape must
(10 mm)
be applied.
max. ø ½
1 "
(38 mm)
*
Edge protector (1) Hexagonal Prefinished toekick (1)
(if services hole socket (2)
white or black
partition is metal) (long & short)
max. 11⁄16
17
(450 mm)
*
"
Water supply
min. 7⁄8
7 "
(200 mm)
110-120 VAC
max. 15 A