Fisher & Paykel DishDrawer DD24DT Series Installation Instructions Manual page 7

(2,1) -2- 599632C DD24D TALL installA2 USCA.indd 15/4/09 11:51:16 AM
(2,1) -2- 599632C DD24D TALL installA2 USCA.indd 15/4/09 11:51:16 AM
10
LEVEL AND SECURE THE PRODUCT
Ensure product is level and
aligning with cabinetry.
Using the most appropriate
C
length Hexagonal socket
supplied, fully extend
levelling feet up to required
distance by hand.
Hexagonal socket
1
B
A
x 4
11
REFIT THE DRAWER
Ensure the drawer clips on
both sides are reset.
5
4
4
Ensure the drawer
is now rotated
clockwise back.
1
2
max. ¾ " (19 mm)
C
optional
The product has three pairs of
mounting brackets: a pair of optional
brackets on the top (C) and two pairs
of formed brackets in the side of the
chassis (A,B). Use at least two out of
the three pairs to secure the product.
Ensure the sound insulation is
repositioned
correctly.
B
A
1
3
3
Before refitting the drawer, ensure the
hoses are not twisted and the latches
at the rear of each drawer runner are
facing forward.
2
10
SECURE THE PRODUCT
Open the upper drawer halfway.
Using a flat-bladed screwdriver, prize
1
the plastic gray plug out of the trim
moulding.
3
4
OPTIONAL
optional
¾ "
max. (19 mm)
4
FINALLY, FOR BOTH METHODS, FIT THE TOEKICK
3
Where the toekick
meets the bottom
of the tub is the
1
cut-off point
2
6 7
8
Using a small Philips screwdriver,
screw through the trim moulding,
securing the side mounting
bracket to the cabinetry. Do not
damage the rubber trimseal.
Replace the plastic gray plug back
into the trim moulding and ensure
the trimseal is facing forward.
Repeat for all four brackets.
5
4
19
19
Important!
9
Do not overtighten screw.
2