GE Profile 24 CustomStyle Owner's Manual page 28

Installing the water line.
Connect the Tubing to the Refrigerator
Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the waft outlet.
We recommend installing a water fiher if your water
supply has sand or particles that could clog tile Connection
soeen of tile refligerator's water valve. Install it in
tile water line near tile retiigerator.
[_] Remove tile plastic flexible cap flOln tile water
valve.
[_ Place tile compression nut and ferrule (slem_e)
onto tile end of the robing as shown.
[_ Insert the end of the copper robing into the
x_vltex valve connection as flu-as possible. While Tubing Clamp - ,.
holding the robing, tighten the fitting.
1/4"
[_] Fasten tile (opper
[tlbing
into tile (lamp Compression _.
provided to h0id it in position. You may
Nut
need to PU open tile clamp. Ferrule
Oneof the illustrationsbelow wi// looklike the connection
on yourrefrigerator
Ferrule 1/4" Compression N ut TubingClamp
/
Tubing
Refrig_
Connection
Turn the Water On at the Shutoff Valve
Tighten any (onne(tions that leak.
Plug In the Refrigerator
Arrange tile coil of copper robing so that it does not
vibrate against the back ofthe refiigerator or against
the wall.
Push tile refiigerator
back to tile wall.
Start the Icemaker
Set tile icemaker tbeler mm to tile ON (dox_ll)
position. The icemaker will not begin to operate
until it reaches its operating/emperamre of 15 OF.
(O°C.) or below. It will then begin operation
automatically if the icemaker teeler arm is in the
ON (down) position.
NOTE:Theicemakermay double-cycle whenit first starts,
causingsomewater spillage from the icemakerinto the
ice bucket.Thisis normalandshouldnot happenagain.
28