Using Your Cooktop - Fisher & Paykel CG603, CG903 User Manual

Using your cooktop

4
Lighting the cooktop
Choose the control knob for the burner you want to use.
1
Press the knob down gently and turn it anticlockwise to
2
the High position. The electrodes on all the burners will
spark.
Flame failure models only: Hold down the knob for
approximately five seconds after the burner has lit.
Releasing the knob too soon will extinguish the flame.
Adjust the flame anywhere between the High and Low
3
positions. Do not adjust the flame between High and
Off O.
Note:
If the burner does not light within 15 seconds, turn the
control knob off and wait at least one minute before
trying again.
If the cooktop does not light
If the cooktop does not light, check that:
The cooktop is plugged in and the electricity is switched on.
The gas is turned on.
The electrodes are sparking.
If the electrodes are not sparking, they may be dirty or wet. Clean them with a toothbrush and
methylated spirits, as shown in Fig. 6.
Electrode
Off
High
Low
Fig.4 Non-jet cooktop controls
(knobs may vary from those illustrated)
Off
High
Low
Fig.5 Jet cooktop controls
(knobs may vary from those illustrated)
Fig.6 How to clean an electrode
Flame failure probe
(some models only)