GE GXSF30V Owner's Manual And Installation Instructions page 15

Programming the Water Softener.
[I
Salt Level
Clock
Hardness
Recharge
I 01"-I'111-1Gollons/Min |
I" _""
" % Remaining
t
I n n I"1 Days to Empty |
[ I _ _ J_ Coil for Service |
1-1 www Recharge Now t _'_'_'_ l_l _)
Tonight e j
When the transformer is plugged into the
electrical outlet, a model code and test number
(example: J3.4 & F30) are shown in the display.
Then, "12:00 pivt'' begins to flash. An arrow _ is
displayed next to CLOCK on the face plate decal.
CONTROL OPERATION:
° CONTROL SETTINGS REQUIRED upon initial
installation and after an extended power outage.
° Use the MODE/SET button to scroll arrow to
desired control function set.
° After the mode is selected use the UP AL. and
DOWN "V" buttons to change the settings of the
control.
° Press the MODE/SET button to accept changes.
° A "beep" sounds while pressing buttons for
control programming. One beep signals a
change in the control display. Repeated beeps
mean the control will not accept a change from
the button you have pressed, and you should
select another button.
SET TIME OF DAY
1. Press MODE/SET button until the arrow
points to CLOCK.
2. Press the UP Ab, or DOWN _r" buttons to set
the present time. UP ,A, moves the display
ahead; DOWN _F" sets the time back. Be sure
AM and PH is correct.
Salt Level [ n.i i'1
PH
Clock
I c,.-ic
Hardness /
Recharge
L
NOTE: Press buttons and quickly release to
slowly advance the display one number at a
time. Hold the buttons down for fast advance.
3. When the correct time is shown in the display,
press MODE/SET to accept.
15