GE GTR10HAX Owner's Manual And Installation Instructions page 11

Installation Instructions
I-_ TRANSFER BOTTOM HINGE
TO THE LEFT
To access the bottom hinge, move the refrigerator
so it is 30" from a wall. Then carefullg tip the
refrigerator back until it rests against the wall.
CAUTION: Se s ure that the coils
on the back of the refrigerator do not rest against
the wall. Doing so could damage the coils.
30 rt
I
|
I
|
Remove the screws (some models hove washers
with each screw), leveling leg and bottom hinge from
the right side. Removethe leveling leg from the left side
of the cabinet and install it in the right side.
Reassemblethe bottom hinge on the left side.
NOTE: The leveling legs are not interchangeable.
151 TRANSFER FRESH FOOD DOOR STOP
TO THE LEFT
Remove the door stop from the bottom of the right
side of the door. Transfer the plug buttons from
the bottom left side to the right side.
Install the door stop on the left side.
i-6-1REHANG THE FRESH FOOD DOOR
Make sure the washer(s)ore in place on the bottom
hinge pin. Placethe fresh food door on the bottom
hinge, close the door and tope it in place with
masking tope.
Removethe plug button from the left edge of the door
and insert it into the hole on the opposite side.
Plug iut _
m INSTALL CENTER HINGE
ON THE LEFT
Removethe three plug buttons on the left side
and install them on the right.
Installthe center hinge designed for the left side
that come with the refrigerator, with the screws, spacer
and washer(s)(on some models) that you removed
in Step 2.
®
®
Removethe tope holding the door shut.
CAUTION:
When assembled correctly,
the hinge is tight against the cabinet.
ATTENTION: T he screws must be properlg tightened.
Turn the screws until snug. Then tighten the screws
a minimum of 1/2 turn using both hands.
11