GE AJCM10ACDW1 Owner's Manual And Installation Instructions page 6

About the controls on the air conditioner-Heat/Cool Models
Appearance may vary.
ON
@ OFF
TIMER
I
• COOL
@ FAN
0 HIGH
• HEAT
® Low
TEMP
I I
ONIOFF
Air Conditioner Controls
Lights beside the touch pads on the air conditioner
control panel indicate the selected settings.
Remote Control
Controls
ON/OFF
Turns air conditioner on and off.
Display
Displaysthe temperature setting. Displays
hours when setting the timer.
MODE
On the air conditioner controls, use to set
COOL,HEATor FAN mode. Indicator lights
on the air conditioner controls will show the
mode selected.
TEMP Increase +/Decrease - Pads
Use to set temperature when in COOL
or HEAT mode.
FAN Speeds
Use to set the fan speed at LOW or HIGH.
Indicator lights will show the speed selected.
TIMER
ON-When the air conditioner is off, it can
be set to automatically turn on in half an
hour to 24 hours at its previous setting.
Eachtouch will set the time in half hours
up to 10 and then in hours up to 24.
To cancel the On Timer, press the ON pad
until "CL" appears. Thenwait until the
display turns off.
OFF--When the air conditioner is on, it can
be set to automatically turn off in half an
hour to 24 hours. Eachtouch will set the
time in half hours up to 10 and then in hours
up to 24.
To cancel the Off Timer, press the OFF
pad until "CL" appears and wait for the set
temperature to be displayed.The unit will
now resume normal operation.
Remote Control Signal Receiver
NOTE:When the air conditioner isturned on,
it will automatically start in the setting last used.
Remote
Control
To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
The remote control signal has a range
of up to 21 feet.
Hake sure nothing is between the air
conditioner and the remote control that
could block the signal.
Hake sure batteries are fresh and installed
correctly-see the Care and Cleaning section.