GE AJCM10ACDW1 Owner's Manual And Installation Instructions page 12

I
stall ti
I str cti
$
Air Conditi er
i lTI Questions?
Call
800.GE.CARES
1800.432.2737)
or Visit our Website at: GEAppliances.com i
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
• IMPORTANT - Sove these instructions
for local inspector's use.
"IMPORTANT - Observe all governing codes
and ordinances.
• Note to Installer - Be sure to leave these instructions
with the Consumer.
• Note to Consumer - Keep these instructions
for future reference.
• Skill level - Installation of this appliance requires basic
mechanical skills.
• Completion time - Approximately 1 hour
We recommend that two people install this product.
• Proper installation is the responsibility of the installer.
Product failure due to improper installution
is not covered under the Warranty.
m
(][)_ ELECTRICALREQUIREMENTSCcont.)
_ o not change the plug on the power cord of
this air conditioner.
Aluminum house wiring may present special
problems-consult a qualified electrician.
Some models require 230/208-volt a.c.,protected
with a time delayfuse or circuit breaker. Thesemodels
should be installed on their own single brunch circuit for best
performance and to prevent overloading house or apartment
wiring circuits, which could cause a possiblefire huzard from
overheating wires.
IMPORTANT!
GE strongly recommends the removal of the old wall case
and the installation of a new GEWall Case. If you DO NOT
use a GEWall Case,you run the risk of poor performance
or product failure. This is not covered under the terms of
the GEwarranty.
Air conditioner break-in period
NOTE - As with any mechanical device with moving
parts, this unit will have a wear-in period. AFTER
INSTALLATION, this unit should be operated for 48
hours to achieve optimum efficiency.
m
_ ELECTRICAL REQUIREMENTS
,WARNING!
Risk of electric shock. Can
cause injury or death. This appliance must be
properly grounded. Where a 2-prong wall outlet
is encountered, it is your responsibility and
obligation to have it replaced with a properly
grounded :3-prong outlet.
(_ ome models require a 115/120-volt a.c.,
60-Hz grounded outlet protected with a
15-amp time delay fuse or circuit breaker.
The 3-prong grounding plug minimizes the possibility of
electric shock hazard. If the wall outlet you plan to use
is only a 2-prong outlet, it is your responsibility to have it
replaced with a properly grounded 3-prong wall outlet.
Do not, under any circumstances, cut or remove
the third (ground) prong from the power cord.
12