GE AJCM10ACDW1 Owner's Manual And Installation Instructions page 19

Installation Instructions
[-6] MEASURE, CUT AND INSTALL FILLER
PANELS
rA1 Measure from the edge of the panel marks
(see Prepare the Window) to the inside of the
window track on each side (A and B).
SII Windowtracl<_
Outside
' A ,4 Widthof the air ---'_' B '
Inside conditioner
Leftside (panel m arl<s) Right s ide
rB] Mark the A and B measurements on each side
of the filler panel board. Cut the panels and discard
the center piece. Note position of the notches.
B
Right
side
a_
FillerPanels
Cutpanels
anddiscard
',center p iece
i A ,
ILeftside
,,
i
o
(D
®
[] Put together the panel assemblies. Remove
the paper backing from the case-side gasket
and attach it to the angle. Push a pencil point
through the gaskets to locate the holes in
the angles.
Gasket
Tab--
s Angle
TypeC
(painted
screws)
r_ Install the panels in the window. Place the spring clips
3" from the top and the bottom. Squeeze and push
the clips to fit in the window track and the tab into
the sill support.
Hook the tab into
the sill support
19