GE AJCM10ACDW1 Owner's Manual And Installation Instructions page 18

Installation Instructions
WINDOW INSTALLATION--OPTIONAL
(cont.)
141PREPARE WINDOW
[_ Mark the centedine of the stool. Measure from the
centerline 13_" on both sides for the panel cuts.
rB] Measure 123A '' from the centerline on both sides
for the sill support brackets.
Centerline
_[ Sill /£
_ 0utside ,/
,'_13_" _13_" _
Inside
Stool
Sill Centerline
Inside
Stool
I_ INSTALL SILL SUPPORTS
r_ Assemble the sill supports. Do not fully tighten
the spacer mounting screws at this time.
Spacer m ounting
screwsType (A)
Spacer
Lock nut-------_
Adjusting bolt--------_
Large washer-------_ _(_
(forusewithwood sills) t
FB1 Before attaching the sill supports, place them on
the window stool. Select the spacer position that
will place the spacer near the outermost point
on the sill. Tighten the spacer mounting screws.
Screwsareinposition
Sillsupport
"V" notch
r_ Turn the bolts and tighten the lock nuts to make
the sill supports level or tilt down 1/8" to the outside.
Line up the "V" notch with 123A '' marks. Drill pilot holes
and attach the sill supports.
Average sill
Sillsupport _!_
-- Spacer
Narrowsill
Offsetsill(suchasbrickor stone)
NOTES:
,, On narrow sills, there may not be enough room to use
the lock nut.
,,A deep offset sill may require a longer adjusting bolt
than the standard hex-head bolt provided.
,, On wood sills use the large washer between the bolt
head and the sill. This prevents the bolt from digging
into the wood.
Sill Bolt --
Outside
18