Ice And - GE Profile 42 Owner's Manual And Installation Instructions

About the ice and water dispenserand automatic icemaker.
A newly &staffed refrigerator may take 12 to 24 hours to begin making ice.
Access Door
IceStorage Bin j@ /_
Mechanism
Ice Storage Bin
Toremove:
I,ift u I) the access door to reach the
icelnaker. Set the icelnaker power switch
to the 0 (off) position. With the access
door closed, support tile storage bin at
the bottoln while slightly litiing. Pull bin
straight out.
Toreplace:
Slide tile bin back until tile tab on
the bin locks into the slot on the shelf.
If tile bin does not go all tile way back,
relnove it aim rotate tile drive n_echaldsm
l/4 tm'n. Then push tile bin back again.
Important facts about your
ice and water dispenser
iJi:: D o not add ice ti'oln trays or bags to tile
storage bin. It may not crush or dispense
well.
iJi:: A void oveHilling glass with ice and use of
narrow or extra-tall glasses. Backed-up ice
canjaln tile chute or cause tile door in
the chute to fl'eeze shut. If ice is blocking
tile chute, poke it through with a wooden
spoon.
iJi:: B everages and fi)ods should not be
quick-chilled in tile ice storage bin.
Cans, bottles or food packages in tile
storage bin may cause tile icemaker
or auger to jam.
_: To kee I) dispensed
ice fl'oln Inissing
tile glass, put tile glass close to, but not
touching, the dispenser opening.
_: Solne crushed ice Inay be disl)ensed
even though you selected CUBED. This
hal)pens occasionally when a ti_w cubes
accidentally get directed to the crushe_:
_: _Mter crushed ice is dispensed, some
water inay dri l) fl'Oln tile chute.
iJi:: T ile fi_t glass of water dispensed inav
be wanner than tile ti)llowing ones.
This is nomml.
10
Automatic Icemaker
A newly-installed refrigerator may take 12-24
hours to begin making ice.
Tile icelnaker will produce seven cubes per
cycle---al)l)roxinmtely 15 cycles or inoi'e in
a 24-hour period, del)ending on freezer
COI//l)_lI'[lllent [ei//l)ei'il[tli'e _ i'ooi//
temperatm'e, imlnber
of door openings
and other use conditions.
If tile refl_igerator is operated before tile
water connection is tnade to the icetnaket;
set tile power switch to 0 (of'[).
When the x'efl_igex'ator has been coxmected
to tile water SUl)pl); set tile power switch to
I (on]. The green light will come on.
Throw away the first fifll bucket ot ice.
Be sure nothing interteres with tile sweep
of the teeler ann.
When tile bin fills to tile level ot tile teeler
aim, the icelnaker will stop produdng ice.
It is nomml fi)r several cubes to be joined
together:
Switch
If ice is not used fl'equenfly, old ice cubes
will become cloud); taste stale and shrink.
_MieI" tile icenlaker has been turned on
again, there will be a delay of about 45
ininutes before tile icelnaker resulnes
ol)erations.
NOtE:In
homes with lowePthan-average
water pressure, you Inay hear tile icelnaker
water wdve cycle on several times when
inaking one batch of ice. Recommended
water pressure is 60 psi.