GE Monogram Owner's Manual page 13

Shelves and Bins
Stainless Steel Refrigerator
Basket
removal (top
drawer)
To Remove the Full-Width Basket on
Top Freezer Drawer Models:
1 Open the top freezer drawer until it stops.
2 Thefreezer basket rests on the inside tabs
on the drawer slides.
3 Lift the front end of the basket so that the front
two alignment tabs come out of the metal slide
bracket first. Then rotate the front edge of the
basket up while lifting the remaining two rear
alignment tabs out of the metal slide bracket.
4 Make sure the plastic sleevesremain attached
to the 4 slots on the metal slide brackets.
When Replacing the Full-Width Basket:
Tilt the basket back and lower it down into
the drawer. Rotatethe basket to a horizontal position
and press it down into the 4 alignment tabs.
NOTE:Always be sure that all 4 basket slots
are engaged in the metal slide brackets before sliding
back into the freezer.
Appearance may vary
Tab
Adjustable
divider in
bottom
freezer
basket
The freezer basket has a divider that can be both
repositioned or removed.
To Remove the Divider in the Bottom
Freezer Basket:
Pull the divider forward until the rear locating tabs
are out of the slots. Turn the divider slightly to the
side to release the front locating tabs and lift out.
To Replace the Divider in the Bottom
Freezer Basket:
Turn the divider slightly to one side so the tabs on
the front fit into the vent slots on the basket. Position
the divider so the back locating tabs snap into place
in the back vent slots.
bs
TO Reposition the Divider in the Bottom
Freezer Basket:
1 Remove the divider as instructed above.
2 Slide the divider left or right to the desired
location and replace as instructed above.
13