GE Appliances JTP13 Use And Care Manual page 21

After Self-Cleaning
You may notice some white ash in the oven. Just wipe
it up with a damp cloth after the oven cools.
If white spots remain, remove them with a soap-filled
steel wool pad. Be sure to rinse thoroughly with a
vinegar and water mixture. These deposits are usually
a salt residue that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
NOTE:
.No functions can be programmed before the door
automatically unlocks.
• If the shelves have become hard to slide, wipe the
shelf supports with cooking oil.
How to Set Delay Start of Cleaning
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
3. Press the STOP TIME pad.
4. Press the INCREASE pad until the desired
Stop Time appears in the display.
Delay Start is setting the oven timer to start the clean
cycle automatically 'at a later time than the present
time of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of day.
1. Follow the directions in the Before a Clean Cycle
section.
Aff_ SELF
I_LEA_
2. After closing the door, press the
AUTO SELF CLEAN pad.
&
3. Press the INCREASE or DECREASE
pad to enter the Clean Time.
STOP /
4. Press the STOP TIME pad. "STOP
TIME" and the earliest Stop Time you
can set will appear in the display.
The earliest Stop Time will be the Clean Time
selected plus the time of day. For example: If
the Clean Time is three hours and the time of day
is 6:00, the Stop Time that appears in the display
will be 9:00.
&
5. Press the INCREASE pad to change
the Stop Time to a later time of day if
desired. For example: If you set Stop
Time at 11:00, oven will start clean
cycle at 8:00 and end at 11:00. The
door latches automatically.
The self-clean cycle will automatically begin after
"CLEAN" is displayed and the time for the clean
cycle is set. The words "ON" and "LOCK" will
appear in the display when the door automatically
locks. It will not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCK light goes off.
6. When the LOCK light is off, open the door.
NOTE:
• During a delayed self-clean operation
you can find out when the oven is set
to turn on by pressing and holding the
AUTO SELF CLEAN pad for 3
seconds.
• A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
(continued next page)
21