GE Appliances 18 Owner's Manual page 17

Connect the Tubing to the Refrigerator
Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
We recommend installing a water filter if your water
supply has sand or particles that could clog the
screen of the refiigerator's water valve. Install it in
the water line near the refrigerator.
V-_Remove the plastic flexible cap from the
water valve.
EffPlace tim compression nut and fetr'ule (sleeve)
onto the end of the ulbing as shown.
[_Insert the end of the copper ulbing into the
water valve connection as f>lras possible. While
holding the ulbing, tighten the fitting.
[_Fasten the copper ulbing into the clamp
provided to hold it in a vertical position.
You may need to PU open the clamp.
1/4" Copper T ubing
I LX
Tubing Clamp
mpression Nut
(sleeve)
Refrigerator Connection
Turn the Water On at the Shutoff Valve
Tighten any connections that leak.
Plug In the Refrigerator
Atr'ange dm coil of copper robing so d_at it does not
vibrate against the back of the refrigerator or against
the wall.
Push the refrigerator back to the wall.
Start the Icemaker
Set the icelnaker feeler am1 to d_e ON (down)
position. The icemaker _411not be_n m operate
until it reaches its operating temperature of 15°F
(O°C) or below. It _411 then be_n operation
automatically if the icelnaker feeler ann is in the
ON (do_m) position.
NOTE: The icemaker may double-cycle when it
first starts, causing some water spillage from
the icemaker into the ice bucket. This is normal
and should not happen again.
17