GE GX1S50F Owner's Manual And Installation Instructions page 4

Performance Data Sheet.
SmartWater Filtration
system
GXIS50F
Using Filter GXRLQR
[] This Sgstem has been tested according to NSF/ANSI 42 and 55 for the
reduction of the substances listed below. The concentration of the indicated
substances in water entering the sgstem was reduced to a concentration
less than or
equal
to the
permissible
limit for water
leavingthe sgstem,
as
specified in NSF/ANSI 42 and 55.
[] Actual
performance
mag varg with local water conditions.
[] Do not use with water that is
microbiologicallg
unsafe or with water of
unknown
qualitg without adequate
disinfection before or after the
sgstem.
Sgstems
certified for
cgst
reduction mag be used on disinfected waters that
mag contain filterable
cgsts.
Hoja de datos de funcionamiento.
Cartucho GXRLQRde sistema de filtraci6n
GE SmartWater GXISSOF
[] Estesistemase ha sometido a las pruebasNSF/ANSI/42 y 53 a fin de reducir
lassustanciaspresentadasa continuaci6n. Seredujola concentraci6n
de las sustanciasindicadas en el agua que ingresanen el sistemaa una
concentraci6n menor o igual al limite permitido para elagua que saledel
sistema,coma seespecificaen NSF/ANSI 4 2 y 53.
[] El desempeflorealpuedevariar de acuerdo alas condicioneslocales
del agua.
[] No use con agua que sea microbial6gicamente insegura o de calidad
desconocida sin una desinfecci6n adecuada del sistema antes o despu@s.
Los sistemas certificados para la reducci6n de esporas pueden set usados
en agua desinfectada que podria contener esporas filtrables.
Parameter
Par6metro
Chlorine/Clara
T&O
Particulate**/
Particulas
USEPA
MCL
USEPA
MCL
Influent
Challenge Concentration
Calidad del
influ_lente concentraci6n
2.0 mg/L ± 10%o
> 10000 particles/
partkulas/mL
Standard No. 42: Aesthetic Effects t Est6ndar No. 42: Efectos est6ticos
Influent Effluent
Average
Promedio
influ_tente
1.88 mg/L
5700000 #/mL
Standard No. 53: Health Effects
USEPA Influent
Parameter MCL Challenge Concentration
USEPA Calidad del
Par6metro MCL influ_lente concentraci6n
Turbidit_/Turbidez 1 NTU*** 11 ± 1 NTU***
CLlsts/Quistes 99.95% red. Min. 50000L
7 8
Asbestos/Amianto 99% red. 10 and/U 10 fibers/fibras/L;
fibers/fibras >10 pm
Ionq/de larqo
Lead/Homo, 0.015 mg/L 0.15 mg/L ± 10%
pH 6.5
Lead/Homo, 0.015 mg/L 0.15 mg/L ± 10%
pH 8.5
Hercurg/Hercurio, 0.002 mg/L 0.006 mg/L ± 10%
pH 6.5
Hercurg/Hercurio, 0.002 mg/L 0.006 mg/L ± 10%
pH 8.5
Lindane 0.0002 mg/L 0.002 mq/L ± 10%
Atrazine 0.003 mg/L 0.009 mg/L ± 10%
Influent
Average
Promedio
influ_]ente
11.18 NTU
220000 #/L
155 MF/L
0.153 mg/L
0.150 mg/L
0.006 mg/L
0.006
mg/L
0.002 mg/L
0.00875 mg/L
Average Maximum
Effluwente
Promedio M6ximo
<0.05 mg/L 0.06 mg/L
30583 #/mL 69000 #/mL
% Reduction
Average Minimum
% de reducci6n
Promedio Minima
>97.26% 96.84%
99.52% 98.94%
' Est6ndar No. 53: Efectos relativos a la salud
% Reduction
Maximum
Effluent
Average
Effluwente
Promedio M6ximo
0.315 NTU 0.049 NTU
0 0
<1 <1
<0.001 <0.001
<0.001 <0.001
0.00026 0.0005
0.0008 0.0015
0.000025 0.00007
<0.002 <0.002
Average Minimum
% de reducci6n
Promedio Minima
97.12% 95.15%
>99.99% >99.99%
>99.99% >99.99%
>99.35% >99.35%
>99.35% >99.35%
98.72% 90.91%
98.72% 75.93%
98.72% 96.50%
76.99% 75.31%
Min. Required
Reduction
Reducci6n
minima necesada
>50%
>85%
Min. Required
Reduction
Reducci6n
minima necesaria
0.5 NTU
>99.95%
99%
0.010 mg/L
0.010 mg/L
0.002 mg/L
0.002 mg/L
0.0002 mg/L
0.003 mg/L
*Tested using a flow rate of 0.78 gpm {2.95 Vmin); pressure of 60 psig; pH of 7.5 ± 0.5; temp. of 68° ± 5°F(20° ± 3°0 / Probado utilizando una tasa de flujo de 0,78 gpm {2,95 I/min); presi6n de 60 psig; pH
de 7,5 ± 0,5; temp. de 68° ± 5° F (20° ± 3° C)
**Measurement in particles/mL Particles used were 0.5-1 microns. / Medid6n en partkulas/mL Las particulas usadas eran de 0,5-1 micr6n.
***NTU-Nephelometric Turbiditg Units / NTU-unidades de turbidez nefelom@rica
O_erating Specifications / Especificaciones de operaci6n
Capacitg: certified for up to 750 gallons {2,838 I); up to six months / Capacidad: certificado para hasta 750 galones (2838 I);hasta seis meses
Pressure requirement: 35-120 psi (2.8-8.2 bar) / Requerimientos de presi6n: 35-120 psi (2,8-8,2 bar)
Temperature: 33-100°F (0.6-38°0 / Temperatura: 33°-100 ° F{0,60-38° C)
Flow rate: 0.78 gpm {2.95I/min) / Tasa de flujo: 0,78 gpm {2,95 I/min)
Replacement Filter Canister/Estimated Replacement Costs
GXRLQR-Replacement f ilter canister $50-5 S
For replacement parts, call toll-free 800.626.2002.
Repuestodel cartucho del filtro/Costos estimados de reposici6n
GXRLQR-Repuestodel cartucho d elfiltro $30-3 5
Para repuestos,Ilame gratis a1800.626.2002 (EEUU.).
4