Panasonic PANATERM Ver. 3.7 Instruction Manual page 26

"Read from the file"
A parameter file (.prm) edited before will be referred to.
Even if the parameters loaded from a file are changed, the
changed parameters will not be introduced to the connected
amplifier unless they are transmitted to the amplifier .
"Read the default"
In the same manner as when the parameters are loaded from
a file, changed parameters will not be introduced to the
connected amplifier unless they are transmitted to the
amplifier.
※When "Read-out from the amplifier" is selected, automatic
loading of parameters can be selected.
"Read from the file" and "Read the defaults" do not provide
automatic loading of parameters.
6 Specify the timing of loading parameters.
"Read whenever the axis address (ID) changes"
Whenever the amplifier (axis address (ID)) to be edited
changes, the parameters are read from the amplifier.
To enable or disable this mode, click on the check box.
"Read whenever the page changes"
When the parameter page to be edited changes,
the parameters are read from the amplifier. To enable or
disable this mode, click on the check box.
－ 25 －