Section 7: Installing And Removing The Door - Montigo H34VO Installation & Maintenance Manual

H-Series VO Outdoor Gas Fireplace
Section 7: Installing & Removing the Door
Removing the door:
The H-Series VO doors are removed in a few simple steps. Follow these
below to remove the Horizontal access panel, unlatch the door buckles
and, remove the door. Replace in reverse order.
Remove the Horizontal Access Panel:
Step 1:
Remove the Horizontal Access Panel:
Remove the Horizontal cover
by placing fingers in both finger
holes, then pushing away from
you and lifting out. Place it
aside during maintenance or
cleaning.
Install in reverse order.
Figure 7. Removing and installing the Horizontal Access Panel
Step 2:
Locate the Door Buckles:
Figure 7a. Locate the door buckles. (Both Sides Typical)
Step 3:
Release the Door Buckles
Hand-hold
Figure 7b. Door buckle Tool
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under door
frame. (as shown)
Figure 7c.
Page 10
Installation
Finger Holes
Installed Gas
Valve Cove r
Door Latch Slot
Door Latch Hook
1
Step 5:
Ensure the tool is firmly
in the lower end of the
slot, (as shown), Then pull
toward you (Caution: hold
the tool securely).
Figure 7d.
Step 6:
Pull hard if necessary to
release the spring ten-
sion. (Caution: The latch
springs back with force,
hold the tool securely).
Figure 7e.
Step 7:
Remove the tool from
the latch slot. Ensure the
latches are hanging freely,
the hook end is released
from the bottom of the door.
(Repeat all 4-steps for the
remaining latches).
Figure 7f.
Step 8:
Removing the Door:
Grasp the Door on either side, usually midway and lift upward, lift
the door carefully up and away from the front of the fireplace. See
Figures 7g. Place the Door aside in a safe place while maintenance
and / or cleaning is being performed.
Figure 7g. Removing and installing the glass doors. (Both Sides Typical)
Installing the Door:
To install the door, hook the top edge of the door frame into place. Lower
the door into position and follow the previous steps shown in reverse order.
2
3
4
XG0150 - 081711