Section Shop Made Safety Accessories - Grizzly G0732 Owner's Manual

SECTION 5: SHOP MADE SAFETY
Featherboards
Making a Featherboard
Material Needed for Featherboard
Additional Material Needed for Mounting
Featherboard in Miter Slot
To make a featherboard:
1.
2.
ACCESSORIES
Step 3
We recommend using a bandsaw for mak-
ing fingers in the next step because it tends
to be safer. A table saw can be used, but it
will over-cut the underside of the ends, pro-
duce a thicker kerf, and require you to stop
the blade half-way through the cut, which
can be dangerous.
3.
79
Figure 79
Figure 79.
IMPORTANT:
Only Steps 1–3 are required to make a
clamp-mounted featherboard. Refer to Page
53 for instructions on clamping.
Figure