Marantz PM-17mk II User Manual page 9

PLAYING PROGRAM SOURCE
q
INPUT SELECTOR
CD
PHONO LINE 1
LINE 2
LINE 3
CD-R
REC SELECTOR
CD
TAPE
PHONES CD-R TAPE LINE 1 SPEAKERS
LINE 2
COPY
LINE 3
PHONO
ON OFF
Playing an analog disk
1. Set the INPUT SELECTOR switch q to PHONO.
2. Play the analog turntable.
3. Adjust the volume with the VOLUME control w.
Caution for analog disk play
- Reduce the volume to the minimum position before replacing
the cartridge or placing the stylus on the disk.
- Do not apply shock to the turntable during play. Otherwise
the stylus may jump and damage the disk surface.
- Avoid installing the turntable near a speaker, for this may
cause howling and make it impossible to increase the listening
volume.
- Do not turn power of the turntable off while the stylus is placed
on a disk.
Playing a CD player
1. Set the INPUT SELECTOR switch q to CD.
2. Play the CD player.
3. Adjust the volume with the VOLUME control w.
Playing a source connected to one of LINE 1 to LINE 3
The source component connected to any of the LINE 1 to LINE 3
input jacks on the rear panel can be played as described be-
low.
1. Set the INPUT SELECTOR switch q to LINE 1, LINE 2 or
LINE 3.
2. Play the component connected to the selected input.
3. Adjust the volume with the VOLUME control w.
Playing a CD-R
1. Set the INPUT SELECTOR switch q to CD-R.
2. Play a pre-recorded disk on the CD recorder.
3. Adjust the volume with the VOLUME control w.
Playing a TAPE
1. Set the INPUT SELECTOR switch q to TAPE.
2. Play a pre-recorded tape on the tape deck.
3. Adjust the volume with the VOLUME control w.
w
VOLUME
20
INTEGRATED AMPLIFIER PM-17
27 15
35 13
43 10
TEMP
58 4
POWER BASS TREBLE BALANCE
0 SOURCE
0 0 DIRECT
(-dB)
2 2 2 2
4 4 4 4
- 6 6 + - 6 6 +
LEFT RIGHT ON OFF
(dB) (dB)
RECORDING OF TAPE DECKS
q
INPUT SELECTOR
CD
PHONO LINE 1
LINE 2
LINE 3
CD-R
REC SELECTOR
CD
TAPE
PHONES CD-R TAPE LINE 1 SPEAKERS
COPY LINE 2
LINE 3
PHONO
ON OFF
r
Recording a CD-R and a tape
A program source such as the analog turntable, tuner or CD
player can be recorded onto CD-R or tape as described below.
Recording of CD
1. Set the REC SELECTOR switch r to CD.
2. Play a CD on the CD player.
3. Operate the CD recorder or the tape deck to start recording.
Recording of analog disk played on the analog turntable
1. Set the REC SELECTOR switch r to PHONO.
2. Play an analog disk on the turntable.
3. Operate the CD recorder or the tape deck to start recording.
Recording of a source connected to one of LINE 1 to LINE 3
1. Set the REC SELECTOR switch e to LINE1,LINE2 or LINE3.
2. Play the source component connected to the selected input.
3. Operate the CD recorder or the tape deck to start recording.
Copying a pre-recorded tape using the REC SELECTOR
switch r
Regardless of the program source selected with the INPUT
SELECTOR switch q, when copying from a CD recorder to a
TAPE deck, set the REC SELECTOR switch r to CD-R Æ
TAPE.
- You can listen to another program source selected with the
INPUT SELECTOR switch q while you are copying.
6
w
VOLUME
20
INTEGRATED AMPLIFIER PM-17
27 15
35 13
43 10
TEMP
58 4
POWER BASS TREBLE BALANCE
0 SOURCE
0 0 DIRECT
(-dB)
2 2 2 2
4 4 4 4
- 6 6 + - 6 6 +
LEFT RIGHT ON OFF
(dB) (dB)