Marantz PS2100 User Manual page 6

CONNECTIONS
A. For Remote control system
1. For Marantz AV system (DR2100, DV2100)
This unit is equipped with the remote control bus function. Connecting
it to Marantz AV system components equipped with REMOTE
CONTROL jacks, such as a CD-Recorder (DR2100) and DVD player
(DV2100), means that these components can be remote controlled
from this unit (PS2100).
Connect the REMOTE CONTROL jacks of this unit to the REMOTE
CONTROL jacks of another component using RCA-type pin lead
provided.
To operate the PS2100 in the SYSTEM mode, the leads from the other
components must be connected to the PS2100.
The lead from OUTPUT terminal of other component is connected to
INPUT terminal of the PS2100. Please refer below.
Note:
If the component connected with the REMOTE CONTROL jacks
has an INT/EXT/SYSTEM switch on the rear panel, set the switch
to SYSTEM position.
2. For Marantz Models or without connecting any component
(Single use)
This unit is equipped with the REMOTE CONTROL bus function. By
connecting it to Marantz system components equipped with remote
control jacks, such as a CD player and MD player, these components
can be remote controlled from this unit. The system control switch
must be set to INT position for single use (no connection to other
components).
Connect the REMOTE CONTROL jacks of this unit to the REMOTE
CONTROL jacks of another component using RCA-type pin lead
provided. Please refer below.
Note:
If the component connected with the REMOTE CONTROL jacks
has an INT/EXT switch on the rear panel, set the switch to EXT.
3. For use in combination with Marantz AV system (DR2100,
DV2100) and other Marantz components
If you connect this unit to the Marantz AV system component, the
system control switch must be set to SYSTEM position.
If other components which are not the Marantz components are
connected, the system control switch must be set to INT position.
Therefore, components other than Marantz AV system are controlled
by their own remote controls.
Connect the REMOTE CONTROL jacks of this unit only to the
REMOTE CONTROL jacks of Marantz AV system, using RCA-type
pin lead provided. Do not connect the remote control cable to the other
models. Please refer below.
B. For Audio signals bus-system
1. For Marantz AV system (DR2100, DV2100)
The SYSTEM IN/OUT terminal is for AUDIO signal input and output.
To use the remote control in the SYSTEM mode (system control
switch set to SYSTEM position), be sure to connect the AUDIO
terminals of the SYSTEM IN/OUT jacks to those of the other
component.
Note:
If these components are to be stacked, always observe the
stacking order shown in this illustration, that is, the receiver on top,
the CD-Recorder in the middle and the DVD player on the bottom.
Be sure to set the main power switches of the DR2100 and DV2100
ON.
2. For other models
The connections for audio inputs and outputs of other models are
connected to the individual terminals, LD/VCD, TV or VCR.
2