Care And Maintenance; Cleaning Of Equipment External Surfaces; Fuse Replacement - Marantz PS2100 User Manual

CARE AND MAINTENANCE

The section describes the care and maintenance tasks that must be
performed to optimize the operation of your Marantz equipment.

CLEANING OF EQUIPMENT EXTERNAL SURFACES

The exterior finish of your unit will last indefinitely with proper care and
cleaning, Never use scouring pads, steel wool, scourging powders or
harsh chemical agents (e.g., lye solution), alcohol, thinner, benzine,
insecticide or other volatile substances as these will mar the finish of
the equipment. Likewise, never use cloths containing chemical
substances. If the equipment get dirty, wipe the external surfaces with
a soft, lint-free cloth.
If the equipment becomes heavily soiled:
- dilute some washing up liquid in water, in a ratio of one part
detergent to six parts water.
- dip a soft, lint free in the solution and wring the it is damp.
- wipe the equipment with the damp cloth.
- dry the equipment by wiping it wit the a dry cloth.

FUSE REPLACEMENT

If a fuse blows, unplug the equipment from the mains supply.
Replace the fuse only with a fuse of the same type and rating.
Replacing the fuse with one of a higher rating or a slower action will
not protect the equipment and will invalidate the warranty. If the
replacement fuse blows again after the equipment is turned on, the
equipment should be taken to an authorized service facility
REPAIRS
Only the most competent and qualified service technicians should be
allowed to service the factory-trained warranty station personnel have
the knowledge and special facilities needed for repair and calibration
of this precision equipment. After the warranty period has expired,
repairs will be performed for a charge if the equipment can be returned
to normal operation.
In the event of difficulty, refer to your dealer or write directly to the
nearest location to you that is listed on the Marantz Authorized
Service Station list. If writing, please include the model and serial
number of the equipment together with a full description of what you
think is abnormal about the equipment's behavior.
18