Clip; Installing The Cover Over The Speaker / Microphone Jacks - Kenwood ProTalk TK-3201 Instruction Manual

I
NSTALLING THE
Do not use glue which is designed to prevent screw loosening when
installing the belt clip, as it may cause damage to the transceiver.
Acrylic ester, which is contained in these glues, may crack the
transceiver's back panel.
I
NSTALLING THE
B C
ELT LIP
If necessary, attach the belt clip using
the two supplied 3 x 8 mm screws.
Note: If the belt clip is not installed, its
mounting location may get hot during
continuous transmission or when left
sitting in a hot environment.
C
OVER OVER THE
If you are not using a speaker/
microphone, install the cover over
the speaker/ microphone jacks using
the supplied 3 x 6 mm screw.
Note: To keep the transceiver water
resistant, you must cover the speaker/
microphone jacks with the supplied
cover.
S / M
PEAKER ICROPHONE
J
ACKS
11