Advertisement
Changing Battery
Troubleshooting
Expected life for a 9 volt alkaline battery is up to 8 hours.
Issue
Total battery life will vary depending upon battery type and
No sound or
manufacturer.
faint sound
Red LED signifies "low battery" with typically less than 60 minutes
of remaining battery life.
Note: Remaining battery life will vary depending upon battery
type and manufacturer.
Wearing the Bodypack Transmitter
Clip the transmitter to belt or
guitar strap as shown.
Distortion or unwanted noise bursts
Make sure the antenna is
unobstructed.
Multiple System Setup
To set up multiple systems, repeat the previous steps for each transmitter and
receiver pair. Once transmitters have been set, leave them on. Be sure to set
Sound level different from cabled
each transmitter and receiver pair to a different channel. For information about
guitar or microphone, or when using
frequencies and compatibility, refer to channel guide.
different guitars
Cannot turn
transmitter on
System Components
LED Status
Solution
All Systems
Transmitter Power/
• Perform transmitter setup.
PG4 or PG88 Receiver
Mute LED on,
• Verify all sound system connections.
Internal Diversity Antenna System
receiver LEDs on
• Adjust transmitter gain.
One 9 volt battery
AC Power supply
Receiver Channel
• Make sure AC adapter is securely
Display off
plugged into electrical outlet and into
POWER connector on rear panel of
Vocalist System
receiver.
Microphone Head
PG2 handheld transmitter
• Make sure AC electrical outlet works
and is supplying proper voltage.
Instrument System
Transmitter LED
• Replace transmitter battery.
glowing
PG1 bodypack
or flashing red
transmitter
Transmitter LED off
• Turn transmitter on.
• Make sure the +/– indicators on battery
Lavalier and Headworn System
match transmitter terminals.
• Insert fresh battery.
PG1 bodypack
transmitter
• Remove nearby sources of RF
interference (CD players, computers,
cell phones, digital effects, in-ear
Replacement Parts
monitor systems, etc.)
• Select a new channel for both receiver
and transmitter.
All Systems
Microphone Stand Adapter (PGX2)
• Reduce transmitter gain.
System-Specific
AC Adapter (120 VAC, 60 Hz)
• Replace transmitter battery.
AC Adapter (220 VAC, 50 Hz), Argentina
• If using multiple systems, change the
channel of one of the active systems.
AC Adapter (230 VAC, 50/60 Hz, Europlug)
• Adjust transmitter gain as necessary.
AC Adapter (230 VAC, 50/60 Hz, UK)
AC Adapter (100 VAC, 50/60 Hz)
AC Adapter (220 VAC, 50 Hz, China)
Transmitter LED
• Replace transmitter battery.
flashing red
AC Adapter (230 VAC, 50 Hz,, Australia)
AC Adapter (220 VAC, 60 Hz, Korea
PG58 Head with Grille
Belt Clip
Optional
Universal Rack Tray
4-pin mini connector (TA4F) to 1/4"
connector cable
Technical Specifications
System
Working Range
75m (250 ft.) Note: actual range depends on RF signal absorption, reflection,
and interference.
User guide
Audio Channel Response
Minimum: 45 Hz.
Maximum: 15 kHz (overall system channel depends on
microphone element).
Total Harmonic Distortion
0.5%, typical
Ref. +/– 33 kHz deviation, 1 kHz tone
Microphone clip
Dynamic Range
>100 dB A-weighted, typical
Operating Temperature
–18°C (0°F) to +57°C (+135°F)
Range
Note: battery characteristics may limit this range
Transmitter Audio Polarity
Positive pressure on microphone diaphragm (or positive voltage to tip of WA302
4-pin mini connector (TA4F) to
phone plug) produces positive voltage on pin 2 (with respect to pin 3 of low
1/4" connector cable
impedance output) and the tip of the high impedance 1/4-inch output.
Microphone (choice of PG185, PG30)
PG1 Bodypack Transmitter
Audio Input Level
–10 dBV maximum at "mic" gain position
+10 dBV maximum at 0dB gain position
+20 dBV maximum at –10dB gain position
Gain Adjustment Range
30 dB
WA371
Input Impedance
1mΩ
PS21
RF Transmitter Output
10 mW typical (dependent on applicable country regulations)
PS21AR
Dimensions
110 mm H x 64 mm W x 21 mm D (4.3 x 2.5 x 0.8 in.)
PS21E
Weight
75 grams (2.6 oz.) without battery
PS21UK
Housing
Molded ABS
PS21J
Power Requirements
One 9V alkaline or rechargeable battery
PS21CHN
Battery Life
Up to 8 hours (alkaline)*
PS21AZ
* See "Changing Battery"
PS21K
PG2 Handheld Transmitter
RPW108
44A8035
Audio Input Level
+2 dBV maximum at –10dB position
URT
–8 dBV maximum at 0dB position
Gain Adjustment Range
10dB
WA302
RF Transmitter Output
10 mW typical (dependent on applicable country regulations)
Dimensions
223.52 L x 53.34 Dia. (8.8 in. x 2.10 in.)
Weight
218 grams (7.7 oz.) without battery
Housing
Molded ABS handle and battery cup
Power Requirements
One 9V alkaline or rechargeable battery
Battery Life
Up to 8 hours (alkaline)*
* See "Changing Battery"
Technical Specifications cont'd
Caution
Changes or modifications not expressly approved by Shure Incorporated for compliance could
PG4 and PG88 Receiver
void the user's authority to operate the equipment. Operation of this device is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the
Output Impedance
XLR connector: 200 Ω
1/4 inch connector: 1kΩ
device.
Audio Output Level Ref. +/–
XLR connector (into 100K Ω load): –19 dBV, typical
33 kHz deviation with
1/4 inch connector (into 100K Ω load): –5 dBV, typical
Patents
1 kHz tone
Patent numbers 6,597,301, 6,296,565, 7,414,587, D536,692 and D535,974
Sensitivity
–105 dBm for 12 dB SINAD, typical
Image Rejection
>50 dB, typical
Dimensions
188 mm L x 103 mm W x 40 mm D (7.4 in. x 4.0 in. x 1.5 in.)
Dimensions - PG88
388 mm L x 116 mm W x 40 mm D (15.3 in. x 4 in. x 1.5 in.)
Weight
241 grams (8.5 oz)
Weight - PG88
429 grams (15.1 oz)
Housing
Molded ABS
Power Requirements
12–18 Vdc at 160 mA (PG4), 320mA (PG88), supplied by external
power supply
Regulatory Information
Regulatory Information for North America, Europe, and Australia
PG1 & PG2 Transmitters: Certified to FCC Part 74 (FCC ID: "DD4PG1" and "DD4PG2").
Certified by IC in Canada under RSS-123 and RSS-102 ("IC: 616A-PG1" and "IC: 616A-
PG2"). Meets the essential requirements of the European R&TTE Directive 99/5/EC (ETSI EN
300-422 Parts 1 & 2, EN 301 489 Parts 1 & 9) and are eligible to carry the CE marking.
PG4 and PG88 Receiver: Authorized under Declaration of Conformity (DoC) provision of
0978
!
FCC Part 15. Certified under Industry Canada to RSS-123 ("IC: 616A-PG4"). This class B
digital apparatus complies with Canadian ICES-003. Meets the essential requirements of the
European R&TTE Directive 99/5/ EC (EN 301 489 Parts 1 & 9, EN 300 422 Parts 1 & 2) and
is eligible to carry the CE marking. Conforms to Australian EMC requirements and is eligible
for C-Tick marking.
N108
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio channel energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
SHURE Incorporated http://www.shure.com
United States, Canada, Latin America, Caribbean:
PS21 Series Power Supplies: Conform to Safety Standard IEC 60065.
5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A.
PS21E and PS21UK are eligible to bear CE marking.
Phone: 847-600-2000 U.S. Fax: 847-600-1212 Int'l Fax: 847-600-6446
A ministerial license may be required to operate this equipment in certain areas. Consult your
Europe, Middle East, Africa:
Shure Europe GmbH, Phone: 49-7131-72140 Fax: 49-7131-721414
national authority for possible requirements.
Asia, Pacific:
This radio equipment is intended for use in musical professional entertainment and similar
Shure Asia Limited, Phone: 852-2893-4290 Fax: 852-2893-4055
applications.
Advertisement
